Replacement of tires with Xiaomi M365: completeness

Xiaomi electric scooter M365 — One of the most popular urban vehicles, even though it wears tires over time, if you notice that the rubber has become hard, cracks have appeared, or the scooter has started to float on a wet road, it's time to think about replacing it. In this article, we will analyze the entire process from choosing a new tire to the final balancing of the wheel - without contacting the service center.

Many owners are afraid to change their own tires. M365, In fact, if you do it right, it takes less than an hour, and you can find all the tools you need in a regular bike shop, and the key is to avoid the typical mistakes, like improper tension of spokes or damage to the camera when you install them. We will discuss in detail at each stage, including the nuances of working with the rear wheel (where the transmission is located) and the front (where it is important to keep the alignment).

When to change the tire: 5 clear signs

Xiaomi manufacturer says standard tires M365 They're designed to run 10,000 to 15,000 kilometers, but the actual duration depends on the style of the ride and the quality of the roads:

• 🔍 Visible wear of the tread: if the depth of the pattern is less than 1 mm, traction with the road deteriorates 2-3 times.
• 💥 Cracks on sidewalls: appear due to aging rubber or driving under low pressure.
• 🌀 «Waves" on the surface: indicate uneven wear (often due to wheel imbalances).
• 🚨 Frequent punctures: if the camera breaks through every 1-2 months, the tire no longer protects it.
• 🛑 Vibrations at speed: may indicate deformation of the cord inside the rubber.

Pay special attention to the rear tire – it wears out 30-40% faster than the front tire due to engine load. If you drive on gravel or wet asphalt, check the tread every 500 km. Ignoring tire wear on Xiaomi M365 Increases the risk of skidding during braking by 5 times – this is confirmed by crash tests of independent laboratories.

⚠️ Attention: Don't confuse tire wear with camera damage! If the scooter is dropping overnight, the problem is more likely a nipple or a puncture than a rubber. Check the camera by putting the wheel in water - bubbles will indicate the location of the leak.

What tires are suitable for Xiaomi M365: comparison

Nana M365 tyre-size 8.5 × 2 camera-inch 8.5 × 1.75–2.125. But not all rubber products of this size are equally good:

For urban driving, the best choice is reinforced Kenda tires. K103 or CST C1408. They're thicker than standard ones. 1–1.5 mm and have an additional layer of cord, which increases the resource 40–50%. If you often drive in parks or primers, look for models with an aggressive tread, such as Innova. 8.5×2.

Important: When buying, check that the tire has markings. ETRTO 47-203 — This is a guarantee of compatibility with the rims M365. Some Chinese analogues (for example, Chaoyang) may have inaccurate dimensions, which will lead to problems in installation.

Replacement tools: what you need and where to buy

For self-replacement of tires on Xiaomi M365 You'll need it:

• 🔧 Installation blades (3 pieces): plastic or metal (but more careful with the rim!).
• 🔩 Wrecks: 5 mm (for spokes) and 15 mm (for rear wheel axis).
• 🚲 Bike pump with pressure gauge (pressure in the chamber should be 35-40) PSI).
• 🧴 Soapy solution or WD-40: It will make it easier to remove the rubber.
• 📏 Line or bar: to check the alignment of the wheel after installation.

If you are changing the tire for the first time, we recommend buying a camera repair kit (patches). + Glue: This is useful if you accidentally puncture a new camera with a mount. All tools can be found in bicycle parts stores (for example, Decathlon or Sportsmaster) or ordered on AliExpress (but you will have to wait 2-3 weeks).

⚠️ Warning: Don't use screwdrivers or knives instead of mounting blades! The risk of damaging the camera or rim increases 3 times. If the blades slide, apply a little bit of the tire to the edge WD-40, But don’t overdo it – the excess can get on the brake pads.

The rear wheel will also require a dynamometer key (or at least manually tightening control) and a tightened axle can deform bearings, and a weak puff will lead to a backlash. The optimal moment for the rear axle nuts is 40-50 Nm.

Step-by-step: how to remove the old wheel

The process of dismantling the front and rear wheels is different, and let's start with the simpler version, the front wheel.

1. Turn off the scooter and turn it upside down (put it on a soft surface so as not to scratch the steering wheel).
2. Lower the camera: unscrew the nipple cap and press the pin inside (a key or screwdriver will fit).
3. Remove brake pads (if they interfere): unscrew the mounting bolt by a key of 5 mm and carefully pull the pads to the sides.
4. Reduce the axle nuts by 15 mm (don’t unscrew completely!).
5. Remove the wheel by pulling the axle out of the fork slots. If the wheel is sour, tap the axis with a hammer through a wooden shelf.

The rear wheel is more difficult due to the presence of the motor and transmission:

Disconnect the scooter from the network and remove the battery|

Take a picture of the motor’s location|

Unscrew 4 bolts of motor mounting (key to 5 mm)|

Reduce axle nuts (key by 15 mm)|

Remove the chain from the star (if it interferes with the)-->

Once the wheel is removed, clear the rim of the old rubber and check it for deformation. Roll the rim over a flat surface — if it hits the sides with an eight, you will need to edit in the bike master's room. Also check the bearings: they must rotate smoothly, without backlash and creaking.

💡

If the axis nuts are stuck, do not try to tear them by force - this is how you can break the thread.°C) or treat with penetrating lubricant Liqui Moly and wait 10-15 minutes.

Installation of a new tire: secrets without mistakes

And the most critical step is to install the new tyre. Here's the algorithm for the front wheel.

1. Check the direction of rotation: there is an arrow on the sidewall of the tire → Rotation. for the front wheel Xiaomi M365 The arrow should look forward (in the course of the movement).
2. Put one side of the tire on the rim with your hands (it should sit easily, without effort).
3. Insert the camera starting with the nipple. Make sure it's not twisted!
4. Fill the second side with mounting blades, starting on the opposite side of the nipple.
5. Pump the wheel to pressure 35 PSI Check if the camera is coming out from under the tyre.

For the rear wheel, steps will be added:

• 🔗 Set the chain on the motor star and adjust the tension (backlash should be 5-7 mm).
• 🔧 Tighten the nuts of the cross-cross axis to avoid skewing.
• 🔌 Connect the motor wires according to the photo taken before removal.

A critical mistake many beginners make is uneven tension of the spokes after installation, which leads to eight wheels and vibrations at speed, to avoid the problem, after installation:

1. Scroll the wheel and check the gap between the tire and the fork/frame – it should be the same throughout the circle.
2. If you notice an imbalance, loosen the spokes with the “convex” side on the 1/4 turn and pull up with the opposite.

Wheel Balancing: Why It Matters and How to Do It

Unbalanced wheel on Xiaomi M365 lead:

• 🌀 Vibrations on the steering wheel at speeds above 20 km/h.
• 🛑 Accelerated wear of bearings and shock absorbers.
• 🔋 Increased battery consumption (up to 10% per 100 km).

For balancing at home:

1. Hang the wheel on a nail or hook by the axle so that it rotates freely.
2. Turn the wheel around, it will stop in the position where the heavy part is at the bottom.
3. Secure the load on the opposite side (you can use coins on scotch).
4. Repeat until the wheel is in any position.

In cycling masters, balancing is done on a special machine with loaders, but for M365 The optimal weight of the loaders is 5-15 grams. After balancing, check the wheel on the move: accelerate to 25 km / h and let go of the steering wheel - if the scooter does not pull to the side, everything is done correctly.

💡

The rear wheel balance is more critical than the front wheel, because the imbalance is more pronounced on the steering wheel because of the weight of the motor. If the vibrations are left after balancing, check the centering of the motor: loosen its mount and adjust the position so that the chain does not sway.

Frequent Mistakes and How to Avoid Them

Even experienced Xiaomi owners M365 Sometimes you make mistakes when you change tires.-5 problems and solutions:

The other thing is, you're working with the camera, and if you notice any cracks or scuffs on it, you better replace it right away. M365 — 8-12 thousand km, but when driving on bad roads, it is reduced to 5-6 thousand. AV13) — they're less likely to poison the air.

⚠️ Warning: If the tire is replaced and the scooter starts to twitch when accelerating, check the rear wheel circuit, it may have jumped off the star or it may be too tight. The optimal chain sagging is 5-7 mm when you press your finger in the middle.

FAQ: Answers to Frequent Questions