Xiaomi electric scooters are some of the most popular vehicles in the city, but their management requires not only basic skills, but also an understanding of technical features, M365 or 1S, The first question that comes up is, how do you stay up, accelerate and slow down? This article will help you understand everything from preparation for the first trip to advanced control techniques.
Xiaomi's scooter design is intuitive, but there are key things that the manufacturer doesn't always say, like why a scooter can bite with its nose when it hits the gas, how to properly distribute body weight when cornering, and why regenerative braking doesn't always save you from locking the wheel. We'll look at these and other questions, drawing on Xiaomi's official guidelines and user experience.
Important: If you've never ridden a scooter (even a non-electric one), start by training on a level ground without traffic. + electronic) require skill to avoid falls.
Preparation of the scooter for the first trip
Before you get on the scooter, check its technical condition. This will take no more than 5 minutes, but will save you from breakdowns and injuries.
- 🔋 Battery charge: Make sure the charge level is not below 30%.A fully discharged battery can cause the engine to suddenly stop.
- 🚲 Tire pressure: Optimal value for Xiaomi M365 — 35-40 PSI, pro 2 — 40-50 PSI. You can check with a manometer (included in the set of some models).
- 🔧 Fixtures: Check the stability of the steering wheel, wings and footrest. Luft in the steering column is a common cause of loss of control.
- 🔦 Lighting and signals: Turn on headlights and rear dimensions. On models without turn signals, use hand gestures.
If the scooter was stored at low temperatures (below) +5°C), let the battery warm up 10-15 minutes before the trip. Xiaomi lithium batteries lose up to 20% of capacity when operating in the cold, and a sharp acceleration can cause a failure of the controller.
⚠️ Attention: Don't ignore the mistake E02 (engine problem) or E07 (Brake failure codes require diagnostics at the service center.
Basic controls: gas, brake, steering wheel
The management of Xiaomi scooter is reduced to three main actions: acceleration, braking and maneuvering. Let's consider each of them in detail.
The right-hand drive is used to accelerate the vehicle, and it is important to press it smoothly, especially in the first meters. Acceleration can cause a loss of balance as the center of gravity shifts backwards. On models with Eco mode (e.g. Pro 2), the top speed is limited to 20 km/h, which is safer for beginners.
Braking is of two types:
- Electronic (left trigger) - smoothly reduces speed, but does not block the wheel.
- Mechanical (rudder lever) - disc brake that completely stops the scooter. Use it only in emergency situations.
For cornering, tilt the steering wheel in the right direction, keeping your balance. The higher the speed, the lower the angle of inclination. At speeds above 25 km/h, a sharp turn can lead to skids.
| Action. | Recommendation | Frequent error |
|---|---|---|
| Dispersal | Smooth press on the gas, body weight is evenly distributed | A sharp start with the transfer of weight to the rear wheel |
| Braking | First the electronic brake, then the mechanical brake. | Simultaneous locking of both brakes |
| Turn. | Steering tilt + turn-over | A sharp jerk of the steering wheel without weight transfer |
💡
If the scooter begins to vibrate when accelerating, check the wheel balance. Most often, the problem is solved by swapping the tires to the recommended pressure.
Safety Techniques: How to Avoid Falls
Statistically, 70 percent of all electric scooter falls are due to a loss of balance or misjudgment of the road situation, and to minimize the risks, follow these rules:
- 🛡️ Protective gear: helmet (required!), elbow pads and knee pads. Even at 15 km/h, falling can cause serious injuries.
- 👟 Shoes: Flat-sole sneakers. Sandals or heeled shoes increase the risk of slipping off the footsteps.
- 🚦 Road conditions: Avoid wet asphalt, gravel and tramways. Brakeways on wet roads increase by 2-3 times.
- 📱 Distractions: Do not use your phone while you are moving.Even a quick look at the screen can lead to loss of control.
Pay special attention to the braking distance. On dry asphalt, at 25 km/h, the scooter stops in 3-4 meters. On wet roads, this distance increases to 8-10 meters. Always keep your distance from pedestrians and vehicles in front.
⚠️ Warning: If the scooter starts to scour (uncontrollably wag) at high speed, immediately turn off the gas and brake smoothly, which may be a sign of wheel imbalance or shock absorbers malfunctioning.
Make sure the battery is charged.|Check the tire pressure|Wearing protective gear|Check the operation of the headlights and brakes|Choose a safe route-->
Driving modes: Eco, Standard and Sport
Most Xiaomi models (e.g. Pro 2 or Xiaomi) 1S) have three driving modes, which differ in maximum speed and responsiveness to gas:
- 🌿 Eco (up to 20 km/h) - Optimal for beginners and saving charge. Acceleration is smooth, braking is mild.
- ⚡ Standard (up to 25 km/h) - balance between speed and safety.
- 🏎️ Sport (up to 30 km/h) – top speed, but requires experience, in which the scooter reacts sharply to gas, which can lead to loss of balance.
You can switch modes by double pressing the power button, and the current mode is displayed on the display (if any) or by indicators on the control panel. M365:
- Green light - Eco;
- Orange is Standard.
- Red is Sport.
For urban conditions, the Standard is recommended. Sport mode is only justified on flat roads without pedestrians and obstacles. Remember: the higher the speed, the less time to respond in an emergency.
How to reset the settings of the modes to the factory?
Emergency situations: what to do if the scooter is out of control
Even experienced riders can get into unforeseen situations, and let's look at the most common cases and how to solve them:
1.Scooter does not respond to gas
Reasons:
- Discharged battery (charge level below 5%).
Overheating of the engine (often occurs during long driving in Sport mode).
- Clogged Hall's sensor in the wheel.
Action
- Stop and check the charge.
- Let the scooter cool for 10-15 minutes.
If the problem recurs, contact the service.
2.The scooter brakes sharply without brake pressing
This could be a regenerative braking operation (when the gas is released) or a malfunction of the controller to avoid falling:
Do not let the gas go off at high speed.
Check your recovery settings in the Mi Home mobile app (if supported by your model).
3.Slip on the turn
Don't stop in the corner, it will make the skid more difficult.
Transfer the weight of the body to the outer leg (relative to the turn).
- Smoothly align the steering wheel.
⚠️ Attention: If the scooter begins to vibrate and squeak when moving, stop immediately.This may be a sign of a bearing jamming or damage to the rim of the wheel!
Optimizing battery power for long-term service
The battery is the most expensive part of Xiaomi’s scooter, and its life is dependent on proper operation. Follow these tips to extend battery life:
- 🔌 Charging: Use only the original RAM. Charge the battery at temperature from +10°C +30°C. Avoid recharging (remove from charging after 100%).
- 🔋 Charge level: Store a scooter with a charge of 40-60%. Full discharge (0%) or constant charge (100%) reduce battery life.
- ⚡ Driving modes: Eco mode increases mileage on a single charge by 20-30% compared to Sport.
- 🌡️ Temperature: Avoid driving in temperatures below -10°C or higher +40°C. Extreme temperatures reduce battery capacity.
The average battery life of Xiaomi is 300-500 full charge cycles, which, if properly operated, will last for 2-3 years of active use. If the scooter starts to discharge faster, check the battery at the service center - it may require replacement of cells.
| Action. | Impact on the battery |
|---|---|
| Charging while +5°C | Reduces capacity by 10-15% |
| Storage with a charge of 0% | It irreversibly damages cells. |
| Use of the Eco regime | Increases resource by 20% |
| Off-road driving | Increases load, accelerates wear and tear |
💡
Regular battery calibration (full discharge and charge up to 100% every 2-3 months) helps to maintain accurate readings of the charge level.
Mobile application Mi Home: setting up and diagnosis
The Mi Home app not only tracks mileage and battery power, but also adjusts key parameters of the scooter.
- Download Mi Home from Google Play or App Store.
- Sign up or sign in to your Xiaomi account.
- Click "Add device" and select your scooter model.
- Turn on Bluetooth on your phone and follow the instructions on the screen.
After you connect, you can:
- View travel statistics (speed, distance, time).
- Set up driving modes (e.g. limiting maximum speed).
- Update the scooter firmware.
Check the status of the battery and engine.
If the scooter makes an error (for example, E05 — The controller problem, the app will show you how to decrypt it and how to fix it, and in some cases, you need to reset the settings to the factory:
1. Turn off the scooter.
2. Press the power button and the brake button for 10 seconds.
3. Wait for the beep.⚠️ Warning: Do not update the scooter firmware through third-party sources, this may result in a controller lock or loss of warranty.