Owners of Mijia devices often face the need to refill supplies, and an automatic soap dispenser is no exception. Although the design seems simple, replacing the cassette or ignoring maintenance rules can lead to machine failure or leaks. In this article, we will discuss in detail the refueling process, the features of different models and secrets that will help the gadget last for years.
Xiaomi Mijia Automatic Induction Soap Dispenser
The first thing you need to do before you start any manipulation is to determine the type of dispenser you have, because the algorithms of actions may differ. Pro series devices and standard versions have different neck designs and feed mechanisms. If you try to pour thick soap into a model designed only for foam, you risk burning the motor or hammering the mesh filter.
It is also important to prepare the workplace, as the process may involve a small amount of liquid spilling over the sink, covering the sink with a towel or performing a procedure over a deep container, which is especially true if you plan to use non-original refill kits, which may require transfusion of the contents.
Model identification and preparation for refueling
Before starting disassembly, carefully inspect the bottom of the case and the markings at the bottom. Xiaomi's original replacement units usually have a special valve that pierces when installed, whereas third-party counterparts may require manual preparation. Understanding the design will help avoid fatal errors during assembly.
Not only will you need a new soap to work, but you will also need a basic set of tools. In some cases, you may need a thin spoke or needle to clean the outlet, and warm water to flush the feed tube. Do not use aggressive chemistry to wash the dispenser itself, as it can damage the plastic and seals.
- 🧼 Original replacement unit or quality liquid for automatic dispensers
- 🔧 Thin needle, toothpick or special needle for cleaning
- 🧤 Disposable gloves and paper towels for hygiene
- 💧 Distilled water for diluting concentrates (if necessary)
Make sure the device is completely dry on the outside before unscrewing the lid.Attachment of moisture on the electronic contacts at the top can cause oxidation or short circuit, which will put the smart dispenser out of action.If you just washed your hands, wipe them thoroughly.
⚠️ Warning: Never attempt to open the top of the dispenser (where the sensor and battery compartment are) by force.
Step-by-step: Replacement of the replacement unit
The most common scenario is to install the original Xiaomi cartridge. It takes less than a minute, but requires care. Take a new soap container and remove the protective film from the top if you have one. Some models also need to remove the transport cap.
Turn the top of the dispenser (motor unit) over or remove it if the design permits. Insert the neck of the new cartridge into the corresponding hole all the way up. You should feel a slight click or resistance, which is replaced by free running - this means that the needle inside the dispenser punctured the membrane of the cartridge.