Replacement of glass on Xiaomi Redmi Note 8 Pro: prices 2026, where cheaper and how not to run into fraud

Xiaomi Redmi Note 8 Pro is still one of the most popular smartphones in the budget segment, despite the release of new models. G90T, 64 MP camera and a capacious 4500 mAh battery make the device relevant even after 4+ But there's a weak spot in the gadget, which is the fragile glass of the screen, and falling from a height of a human being or a botched impact often causes cracks, chips, or a complete failure of the display.

If you're faced with a broken screen, the first question that comes up is, "How much does it cost to replace the glass with a Redmi Note 8 Pro?" The answer depends on many factors: the type of damage, the quality of the part, the region, and even the time of year (in the New Year's Eve, prices are often overpriced).

  • ⚠️ Typical cheating schemes and how to avoid them

It's important to understand that in the Redmi Note 8 Pro, the glass and touchscreen (touch layer) are combined with the sensor into a single module, which means that if you get serious damage, you have to change the entire display module, not just the protective glass, and the final cost of repair depends on this.

1.How much does it cost to replace glass on Xiaomi Redmi Note 8 Pro in 2026: price table

Repair prices vary depending on the type of spare part, region and status of the service center. Below is an up-to-date table with indicative rates for Moscow, St. Petersburg and the regions of Russia. Note that in small cities the cost can be 10-20% lower, but the quality of services is often worse.

Type of spare partMoscow/SPB (β‚½)Regions (β‚½)What's in the price
Original Display Module (Xiaomi)8 500 – 12 0007 000 – 10 000Module + job + diagnostics
High quality analogue (A)+ grade, for example, Tianma or BOE)5 500 – 7 5004 500 – 6 500Module + work, guarantee 3-6 months.
Budgetary analogue (C grade, unknown manufacturer)3 000 – 4 5002 500 – 4 000Module + work, warranty up to 1 month or no
Only the protective glass (if the matrix is intact)1 500 – 2 5001 200 – 2 000Removal/installation of glass + UV glue

Important: 90% of cracks on the Redmi Note 8 Pro require the entire display module to be replaced, not just the glass. OGS (One Glass Solution, where the touch layer is fused into the glass and does not separate without damage, if the master suggests replacing "glass only" for 1000-1500 β‚½, He probably means a tape sticker or a low-quality repair with the risk of losing touchscreen sensitivity.

Xiaomi’s official service centers typically cost 15 to 25 percent more than private ones, but they give a 12-month warranty and use original parts. For example, Mi Service will cost 10,000 to 11,500 to replace the display. β‚½ (2026).

πŸ“Š Where do you plan to repair your smartphone?
Official Xiaomi service
Private workshop
Independently.
I haven't decided yet.

Original vs Analog: What to Choose for the Redmi Note 8 Pro?

When you replace the display, you'll be offered a choice of original parts or analogues, and we'll look at the pros and cons of each option.

πŸ”Ή Original Display Module

  • βœ… 100% compatibility – no problems with color calibration, touchscreen sensitivity or sensors.
  • βœ… 12 months in official services guarantee (up to 6 months for private clients).
  • βœ… Factory standards compliance – brightness, contrast and viewing angles are identical to the native screen.

Cons: high price (from 8000) β‚½) Deficiency: Original modules often have to be ordered on hold (2-7 days).

πŸ”Ή High quality analogue (A)+ grade)

  • βœ… Prices are 30-40% lower than the original (5000-7000) β‚½).
  • βœ… Quality close to the original – matrices from the same suppliers are used (Tianma, BOE), what's Xiaomi.
  • βœ… 3-6 months warranty in most workshops.

Cons: there may be minor differences in color reproduction (colder or warmer shade), rarely - reduced brightness by 5-10%.

πŸ”Ή Budgetary analogue (C grade)

  • βœ… Lowest price (2500–4000) β‚½).
  • ❌ Marriage risk – broken pixels, uneven lighting, β€œyellow” corners.
  • ❌ Lifetime – these screens often fail after 6-12 months.
  • ❌ Problems with touchscreen - delays when touching, "ghost" presses.

⚠️ Note: In some workshops, under the guise of "original", they sell analogues with a Xiaomi sticker. You can verify the authenticity by the serial number of the module (should match the data in the system) or by the quality of the assembly - the original has no backlashes and gaps between the frame and glass.

πŸ’‘

If the smartphone is warranty, it is better to replace the display in the official service - otherwise the warranty on the entire device will burn.

3. Where is it cheaper to replace glass: a comparison of options

The choice of a repair site depends on your budget, timeframe and willingness to take risks, and consider all options from official services to garage craftsmen.

🏒 Official Xiaomi Service Center (Mi Service)

Pros:

  • βœ… Original parts with 12 months warranty.
  • βœ… Professional equipment (e.g. station) JCID-8800 display-test).
  • βœ… Keeping a smartphone warranty (if it is still valid).

Cons:

  • ❌ Highest price: from 10,000 β‚½).
  • ❌ Long repair period (3-7 days if no module is available).
  • ❌ Tough rules – for example, may refuse repairs if the smartphone was opened earlier.

πŸ”§ Private service centres

It's the best price-performance model. Good workshops use A analogues.+ Average repair costs are between 5,000 and 7,000 months. β‚½.

How to choose a reliable workshop:

  • πŸ” Check reviews on Yandex.Maps or 2GIS (especially pay attention to the before / after photo").
  • πŸ“„ Ask what brand of display is installed (should be called Tianma, BOE or Truly).
  • πŸ›‘οΈ Check whether they give a guarantee for work and spare parts (must be spelled out in the contract).

πŸ‘¨β€πŸ”§ "Artisanal" masters (advertisements on Avito, VK)

Pros: price from 3,000 β‚½, You can arrange for urgent repairs (in 1-2 hours).

Cons:

  • ❌ No guarantee (or she's "in word").
  • ❌ Risk of installing a defective module (for example, with broken pixels).
  • ❌ Often use cheap glue, which can detach the glass in a month.

⚠️ If the master offers to replace the glass for 1500-2000 β‚½ "Without removing the module, he'll probably just stick a protective film over the cracks, and that repair will last a week.

Step-by-step instructions: how to replace glass yourself

Replacing the display module at home is a daunting task, but it’s doable if you have experience with electronics. For the Redmi Note 8 Pro, the process is complicated by:

  • πŸ”Œ Fragile plumes (especially cameras and display).

If you are planning to repair yourself, follow this instruction:

Purchase a new display module (original or analogue A)+ grade)|Set of screwdrivers (cross, flat, Pentalobe) P2)|Plastic blades for opening the body|Hair dryer or heating station (for softening glue)|Tweezers and screen-suction cups|Double-sided tape or glue B-7000 fixation-->

πŸ”§ Step 1: Preparing and disassembling the smartphone

  1. Turn off the phone and remove it. SIM-memory-card.
  2. Heat the screen edge dryer (~60Β°C) for 2-3 minutes to soften the glue.
  3. Carefully tuck the lower edge of the body with a plastic spatula and insert a suction cup into the slot.
  4. Pull the suction cup up while simultaneously swiping the shoulder blade around the perimeter to separate the screen from the frame.

πŸ”§ Step 2: Disconnect the plumes and battery

  1. Unscrew 4 screws that fix the metal plate over the battery.
  2. Disconnect the battery plume (use a plastic blade to avoid damaging the contacts).
  3. Carefully turn off the plumes of the display, touchscreen and front camera (they are located under the metal screen).

πŸ”§ Step 3: Installation of a new module

  1. Remove the old display module and clean the frame of the glue residue (use isopropyl alcohol).
  2. Apply a new bilateral scotch or glue B-7000 perimeter.
  3. Connect the plumes of the new module and gently press it to the body.
  4. Twisting the screws and checking the screen before final assembly.

⚠️ Note: If you replace yourself, you risk damaging the fingerprint plume (under the display). If the scanner stops working after assembly, additional repairs will be required (cost: from 1500). β‚½).

πŸ’‘

Before assembly, check the tightness of the case - if there are gaps, moisture can get inside and cause corrosion of the board.

5. Typical schemes of cheating when replacing glass

The smartphone repair market is teeming with scammers who use unfair schemes to make money, and here are the most common tricks faced by Redmi Note 8 Pro owners:

  • πŸ’Έ "Diagnosis" for 1000-1500 β‚½ β€” Some workshops charge you for the inspection, even if you don't agree to the repair.
  • πŸ”„ Part swaps -- they give you a cheap version, and they charge you like the original. What to do: Require you to show the package from the serial number module.
  • ⏳ "Urgent repairs for double the price - the master says he can do everything in 1 hour, but the price increases by 30-50.
  • πŸ”§ Additional "breakdowns" - after repairs, it suddenly turns out that the camera or speaker is not working.
  • πŸ“± "Data recovery for a fee – if the screen crashed but the phone turned on, the data can be copied for free through the OTG-What to do: Don't settle for paid recovery.

To avoid cheating:

  1. Check the phone for performance before payment (screen, touchscreen, cameras, speakers, fingerprint scanner).
How to check the originality of the display module?
Original module for Redmi Note 8 Pro has: 1. Serial number that matches the data in the system (Settings) β†’ The phone. β†’ Version. MIUI). 2. Xiaomi logo or Tianma/BOE backstretch. 3. Smooth backlight without yellow spots and broken pixels. 4. Clear operation of the touch screen without delay.

Alternatives: when glass replacement is not feasible

Sometimes repairing the Redmi Note 8 Pro is so expensive that it is cheaper to buy a new smartphone.

  • πŸ’₯ Not only is the matrix damaged, but the board is damaged, and if the phone doesn't turn on or overheats after the fall, the problem may be a short circuit. β‚½ + screen-price.
  • πŸ”‹ Battery swollen - battery replacement (+ display) will pull by 7000-9000 β‚½. In this case, it is more logical to sell the phone for spare parts and buy a new one.
  • πŸ“‰ The smartphone is outdated morally – if you were planning to upgrade soon, it may be better to invest in a new model (for example, the Redmi Note 12 Pro).

The cost of the redmi Note 8 Pro in good condition for 2026 – 6000-9000 β‚½. If the screen repair costs the same amount, it makes sense to consider alternatives:

OptionCost (β‚½)PlusesCons
Buy a Redmi Note 8 Pro with a full screen6 000 – 9 000New body, battery in better conditionRisk of hidden defects (checking is required!)
Buy the new Redmi Note 1212 000 – 15 000Relevant iron, 12 months warranty.You will have to move data and get used to the new interface.
Sell for spare parts + buy up3,000 to 5,000 (per spare parts) + differenceYou can get some money back.We'll have to find a buyer.

⚠️ Warning: If you decide to sell a broken-screen phone, please include the exact cause of the breakdown in the ad (e.g., β€œCracks on the matrix, touchscreen works.

FAQ: Frequent questions about replacing glass with Redmi Note 8 Pro

❓ Can you replace only glass without touching the matrix?
99% of the time, no. The Redmi Note 8 Pro uses technology. OGS, where the glass, touchscreen and matrix are soldered into a single module, except for small cracks without damage to the touchscreen, but even in this case the quality of repair will be low (risk of detachment, cloudy screen).
❓ How long does it take to replace the screen?
In the service center, it takes 1 to 3 hours (if the module is available); in the private workshop, it takes 30-60 minutes; in self-replacement, it takes 2-4 hours for beginners (taking into account disassembly and inspection).
❓ Will you give a guarantee if the phone was in the water?
No, any traces of liquid (oxidation on the board, corrosion) are grounds for refusing warranty repairs. Even if the screen crashes after water hits, the workshops do not undertake such repairs or give a maximum warranty of 1 month.
❓ Why the screen scanner does not work after replacing the screen?
The fingerprint scanner in the Redmi Note 8 Pro is built into the display module, and if the wizard has damaged the plume or installed an incompatible part, the scanner will stop working, so the solution is to reconnect the plume or replace the module with a compatible one.
❓ Can I use a phone with cracked glass?
You can, but with reservations: βœ… If the cracks are only on the glass and the touchscreen works, yes. ❌ If the matrix is damaged (colored stripes, artifacts appeared) – no, it can lead to poor vision. ❌ If the glass begins to crumble, it is dangerous (you can injure your fingers), and remember that cracks worsen the tightness of the case, which increases the risk of moisture and dust.