Replacement of glass on Xiaomi Redmi 8 Pro: prices 2026, where cheaper and how to save

The cracked glass on the Xiaomi Redmi 8 Pro is a problem that almost every smartphone owner faces after 2-3 years of active use. Even a minor scratch can eventually grow into a web of cracks, and falling from a height of human growth is almost guaranteed to lead to a complete replacement of the protective glass. But how much will it cost in 2026? The answer depends on many factors: from the type of glass (original or analogue) to the region and level of the service center.

In this article, we will discuss the current prices for glass replacement for the Redmi 8 Pro in official and informal services, compare the cost of original parts and Chinese counterparts, and also tell you how to save up to 40% without loss of quality. You will learn how much it will cost to repair if only the external glass is damaged (without a sensor) and what to do if the entire display module cracks.

How much does it cost to replace glass on the Redmi 8 Pro in 2026: a comparison of prices

The cost of repair depends on which item is damaged. 8 Pro (model) M1910F4G) The glass can be replaced separately from the sensor layer only in the 30% In other cases, it depends on the nature of the damage, and the entire display module needs to be replaced, which is expensive. 2-3 more expensively.

The following table shows the current prices for June 2026 (including work and parts) and is based on monitoring of 15 service centers in Moscow, St. Petersburg, Yekaterinburg and Novosibirsk, as well as user feedback on 4PDA and Mi Community forums.

Type of repairOfficial Xiaomi serviceAuthorized partnerInformal workshopSelf-sustaining replacement
Exterior glass only (without sensor)4 200 β€” 5 800 β‚½3 500 β€” 4 500 β‚½2 800 β€” 3 800 β‚½1 200 β€” 2 000 β‚½(glass-price)
Display module whole (glass + sensor + matrix)7 500 β€” 9 200 β‚½6 000 β€” 7 500 β‚½4 500 β€” 6 000 β‚½3 200 β€” 4 800 β‚½(module)
Xiaomi original glass (only in official centers)5 200 β€” 6 500 β‚½β€”β€”β€”
High quality analogue (e.g. Tianma or BOE)β€”3 800 β€” 4 800 β‚½3 000 β€” 4 000 β‚½1 800 β€” 2 500 β‚½

⚠️ Note: Prices in official Xiaomi services include a guarantee to work before 12 They often refuse to repair smartphones with traces of previous autopsies or unofficial repairs. 3-6 months, but the masters make concessions on price and timing.

If you are asked to replace the glass for 1 500–2 000 β‚½ in an unknown workshop, most likely, this is a low-quality analogue with the risk of detachment through 2-3 These windows often have the worst light transmission and distort the color of the screen.

πŸ“Š Where do you plan to repair the Redmi 8 Pro?
In the official service Xiaomi
An authorized partner
In a verified unofficial workshop
Independently.
I haven't decided yet.

Previous Previous post: What to Choose for Redmi 8 Pro

The main question when replacing glass is to take the original spare part from Xiaomi or save on an analogue. The price difference can reach 2-3 thousand rubles, but the overpayment is not always justified.

The original Xiaomi glass (MI Original)

  • βœ… Perfect match in color reproduction and brightness (no yellowness or blue).
  • βœ… Guarantee from the manufacturer (in official services).
  • βœ… High strength - withstands falls from a height of up to 1 meter on a hard surface.
  • ❌ Price 1.5-2 times higher than analogues.
  • ❌ Long delivery time (if not in stock).

Quality analogues (e.g. Tianma A+, BOE Premium, Truly):

  • βœ… Prices 30-50% lower than the original.
  • βœ… Quick replacement – usually available.
  • βœ… 90% of the quality of the original (only an experienced user will notice the difference).
  • ❌ There may be slight variations in color reproduction (especially on a white background).
  • ❌ Service life is 10-15% less (2-3 years vs. 3-4 from the original).

Cheap analogues (unnamed Chinese glass):

  • βœ… Price from 800 β‚½ (Sometimes cheaper than a replacement).
  • ❌ Risk of detachment after 1-2 months.
  • ❌ Poor Sensitivity of the Sensor (Delays in Pressing).
  • ❌ Color distortion (yellow or blue shade).

πŸ’‘ Tip: If you are not willing to pay for the original, choose analogues marked A+ Premium from the manufacturers of Tianma or BOE. They are used even in some official services, but sold under a different brand.

πŸ’‘

Before changing the glass, check to see if the extended warranty on your Redmi 8 Pro has expired. Some banks (Tinkoff, Sber) give free repairs if the screen is damaged during the first year of smartphone ownership.

Where to replace glass cheaper: TOP-5 options

The price of the repair can vary by 2-3 times depending on where you go, and we analyzed user reviews and ranked the most profitable and reliable options for replacing glass with the Redmi 8 Pro.

  1. Official Xiaomi Service Centers βž• 12 months warranty, original parts. βž– Highest price: from 4,200 β‚½), Long-term repairs (3-7 days).
  2. Authorized partners (e.g., "Spoke Service", "TechnoDrive") βž• Price 15-20% lower than the official, 6 months warranty. βž– Sometimes they use analogues under the guise of originals.
  3. Network workshops (iFix, Phone Repair, Fix Price") βž• Quick (1-2 hours), price from 2,800 β‚½. βž– Quality depends on the particular master.
  4. Local workshops (according to recommendations) βž• Lowest price: from 2,500 β‚½), personalization. βž– The risk of running into unscrupulous masters.
  5. Self-sustaining replacement βž• Savings up to 50% (glass) + The tools will cost 1,500-2,500 β‚½). βž– High risk of damage to plumes or matrix.

⚠️ Avoid workshops that offer glass replacement for 1,500–2,000 β‚½ It's 1 hour, and most often it means using cheap glue, which in a month will start peeling off, and the sensor will stop responding to touching the edges.

Important fact: In 2026, Xiaomi’s official services began refusing warranty repairs for smartphones older than 3 years (including the Redmi 8 Pro, released in 2019), even if the damage was caused by the user.

Self-replacement of glass: step-by-step instructions

If you decide to save and replace the glass with Redmi 8 Pro with your own hands, you will need:

  • πŸ”§ Set for disassembling smartphones (iFixit Pro Tech Toolkit or similar).
  • πŸ”₯ dryer or heat tile.
  • 🧴 Clay. B-7000 or LOCA fixing.
  • πŸ“± New glass (recommended Tianma A)+ or BOE Premium).
  • 🧀 Gloves and mask (when working with glue and glass dust).

πŸ“Œ Procedures for action:

β˜‘οΈ Preparation for glass replacement on Redmi 8 Pro

Done: 0 / 5

πŸ”§ Installation of new glass:

  1. Apply a thin layer of LOCA glue to the inside of the new glass.
  2. Carefully press the glass against the display module, avoiding bubbles.
  3. Place the phone under the UV lamp for 5-10 minutes to polymerize the adhesive.
  4. Check the sensitivity of the sensor with the test ##6484##.

⚠️ Warning: If the glass is replaced and it moves around the edges or if it gets iridescent, it means that the glue is not uniformly applied, and then you have to repeat the procedure, otherwise dust and moisture will clog under the glass.

What if the glass does not respond to touch after replacement?
This means that when disassembling the sensor plume was damaged or it is not tightly connected. Try: 1. Turn off the phone and remove the battery for 1 minute. 2. Check the density of the connection of the plume to the motherboard. 3. If the problem persists, you need to replace the sensor module (cost from 2,500). β‚½).

Frequent mistakes when replacing glass and how to avoid them

Even experienced craftsmen sometimes make mistakes that lead to additional costs, and here are the most common problems and ways to prevent them:

Mistake.Effects of consequencesHow to avoid
Use of cheap glueGlass leaves after 1-2 months, dust hitUse only LOCA or B-7000
Overheating of the screen with a phenomeDamage to the matrix (the appearance of broken pixels)Keep the temperature not above 70 Β° C, warm up no longer than 3 minutes
Sloppy glass smackingBreaking of sensor or matrix plumeUse plastic blades, not metal ones
Uneven pressing of glassBubble under glass, distortion of the imagePress the glass with a roller from the center to the edges

πŸ’‘ Useful tip: Before starting the repair, take a picture of the location of all the plumes and screws. Redmi 8 Pro uses 3 types of screws (Y000, T3, T5), And if you mix them up, you can damage the fee.

If you're not sure about your abilities, you should go to the workshop. The average cost of "resuscitation" Redmi 8 Pro after a failed self-replacement glass is 5,000-7000. β‚½ (matrix-replacement + plumes).

How to Save Money on Glass Replacement: 5 Ways to Work

Replacing glass with the Redmi 8 Pro can be cheaper if you use one of the proven ways to save money:

  • πŸ›’ If you have friends with the same model, you can order 2-3 glass on AliExpress at a wholesale price (from 800). β‚½ one piece) and replace together.
  • πŸ”§ Self-replacement with rental tools. Some workshops rent out repair kits (500-800) β‚½/day-day).
  • πŸ“² Use of promotional codes: Services like Fix Price or iFix often offer 10-15% discounts for reviews or promotional codes (for example, for example, for the user, MIREPAIR10).
  • πŸ”„ On Avito or Yula, you can find display modules from broken Redmi 8 Pros for 1,500-2,500 β‚½.
  • πŸ“… In January-February and August-September, the demand for repairs falls, and many workshops make discounts up to 20%.

⚠️ Warning: Don't buy glass from unknown Chinese sites without reviews. In 2023, fraud cases where Tianma A glass is replaced by glass increased.+ They sent low-quality fakes without oleophobic coating (fingers stick to the screen).

πŸ’‘

The most reliable way to save money is to find a workshop that gives you a guarantee of at least 6 months, and even if the price is 10-15% higher, it will protect you from repeated spending.

FAQ: Answers to Frequent Questions About Replacing Redmi 8 Pro Glass

Can only the glass be replaced if only the top layer is cracked and the sensor is working?
Yes, but only if the cracks don't affect the sensor layer, and 70 percent of the time, if the outer glass is severely damaged, the entire display module needs to be replaced, because there's a high risk of damage to the plumes when disassembling, and only a master can make an accurate diagnosis.
How long does it take to replace glass in the service?
Xiaomi’s official service is 3-7 days (due to queues and waiting for parts); in informal workshops, 1 to 3 hours; self-replacement for beginners takes 4-6 hours.
Will Face Unlock work after the glass is replaced?
If you only replace the external glass, Face Unlock will continue to work. If the entire display module has changed, you may need to reconfigure the facial recognition in the Settings β†’ Biometrics and Security menu.
Can I glue the Redmi 8 Pro protective glass over a cracked one?
No, it's going to make things worse. The cracked glass has sharp edges that can damage the new protective glass and make the damage worse. It also puts a strain on the sensor, which can cause it to fail.
What if the screen turns yellow after changing the glass?
This is a sign of using low-quality glass with poor light transmission, the only way out is to re-replace it with A+ or original glass, sometimes by calibrating the color in the engineering menu (#36446337##), but the effect is temporary.