Xiaomi Mi A3 — pop-up AMOLED-It's a display, but it's vulnerable to mechanical damage, and if you drop your phone or notice cracks, broken pixels, stripes on the screen, you should think about replacing the display. In this article, we'll look at how much it costs to replace the screen with Mi. A3 in 2026, where it is better to repair, which modules to choose and what to pay attention to, so as not to overpay.
The cost of repair depends on the type of display (original or analog), region, status of the service center and the complexity of the breakdown. For example, replacing a sensor with cracks will cost less than replacing a full sensor. AMOLED-We've analyzed the formal and informal workshops so you can compare the options and choose the best one.
How much does it cost to replace the display on Xiaomi Mi A3: current prices 2026
The cost of repairs varies depending on the type of screen and region, and below we will show the average prices in Russia and CIS countries (including work and parts).
| Type of display | Cost (₽) | Cost (₴/BYN) | Where do they offer? |
|---|---|---|---|
| Original display (OEM) | 8 500 – 12 000 | 3 500 – 5 000 / 280 – 400 | Official SCCs, Authorized Workshops |
| High quality analogue (A+) | 5 000 – 7 500 | 2 000 – 3 200 / 160 – 240 | Private workshops, services with guarantee |
| Medium quality analogue (A) | 3 500 – 5 000 | 1 500 – 2 200 / 120 – 180 | Budget workshops, without long-term warranty |
| Sensor only, no AMOLED-panel) | 2 500 – 4 000 | 1 000 – 1 800 / 80 – 140 | If only the touchscreen is damaged |
⚠️ Attention: Prices are job-based, and some workshops may charge a separate diagnostic fee (300-800). ₽). Also, the cost depends on the condition of the case - if the frame bent when falling, it will have to be straightened or replaced, which will increase the price by 1,500-3 000. ₽.
In Moscow and St. Petersburg, repair costs 10-15% more than in the regions, for example, in Kazan or Novosibirsk, it can cost 4,500 to replace an analog display. ₽, And in the capital, it's 6,000. ₽. In Belarus and Kazakhstan, prices are comparable to regional prices in Russia.
Original vs analogue: which display to choose for Mi A3
The main question when replacing a screen is to take the original part or the analogue. Original displays guarantee full compatibility, but they are expensive. Analogs are cheaper, but they may have disadvantages. Let's take a look at the pros and cons of each option.
- ✅ Original display (OEM): — Full compliance with factory parameters (color reproduction, brightness, sensor sensitivity). - Warranty from 6 months to 1 year in official SC. - No problems with display (no "yellow shade", broken pixels). ❌ Cons: high price and deficit in some regions.
- ✅ High quality analogue (A)+): — Color reproduction is close to the original (may differ by 5-10%). – Warranty 3-6 months. – Price 30-50% lower than the original. ❌ Cons: there may be minor differences in brightness, sometimes worse oleophobic coating.
- ⚠️ Medium quality analogue (A): – Noticeable differences in color reproduction (can be cold or warm). – Warranty 1–3 months or no. – Often pixels burn out faster. ❌ Cons: possible problems with multi-touch, less sensitivity of the sensor.
Critical nuance: on the Mi A3 The original displays are often framed and the counterparts are separate, which means that when you install the analog, the wizard will have to carefully separate the old frame, which increases the risk of damage to the case.
If you want to be perfect and durable, you'd better pay extra for the original, and if the phone is used as a workhorse and the differences aren't critical, a class A is a good fit.+.
💡
Before you change the display, check if the warranty period on the phone has expired. A3 If you are still under warranty, and the screen crashed due to your fault, the official service may refuse free repairs, but will offer a replacement at a fixed price (usually cheaper than the market).
Where to change the screen Xiaomi Mi A3: comparison
The choice of a workshop affects not only the price, but also the quality of the repair, and let's look at all the options, from official services to self-replacement.
1. Official Xiaomi Service Centers
✅ Pluses:
Work and parts warranty (usually 1 year).
- They use original displays.
Professional equipment for diagnostics.
❌ Cons:
— Highest price: from 10,000 ₽).
Long term repair (3-7 days).
- You may need to pay in advance.
2. Authorized partner workshops
✅ Pluses:
Prices are 15-20% lower than in official SCs.
- 6-12 months warranty.
- Faster deadlines (1-3 days).
❌ Cons:
There are not always original parts.
The quality of the work depends on the particular master.
3. Private workshops and repair points
✅ Pluses:
— The lowest prices (from 3,500) ₽ analogue).
- The possibility of replacing "while you wait" (1-2 hours).
Flexible conditions (sometimes you can negotiate a discount).
❌ Cons:
The risk of getting into poor quality parts.
Warranty is often limited to 1-3 months or is not available.
No checks (problems with claims).
4. Self-substitution
✅ Pluses:
Minimum costs (only the cost of the display)
Experience in repairs (good for the future)
❌ Cons:
High risk of damage to plumes or motherboard.
- No guarantee.
A special tool is required (suction cup, mediator, hair dryer).
🔧 Tip: Before choosing a workshop, read reviews on Yandex.Maps or 2GIS. Pay attention to complaints about poor color reproduction after replacement or rapid failure of the screen - these are signs of poor quality spare parts.
How to check the workshop before repair?
Step-by-step: how to prepare for a display replacement
If you decide to put your phone in repair, follow these steps to avoid problems:
Make a backup copy of the data (photos, contacts, messages)
Turn off the phone and remove it. SIM-memory-card
Write it down. IMEI (06# in case of repair check
Take a picture of the phone’s appearance (to capture the initial state)
Check if the “Find My Device” function is enabled (in case of loss in the workshop)-->
⚠️ Attention: If on Mi A3 You have a pattern lock or password, you have to turn it off before you repair it! Many workshops reset the phone to factory settings if they can't unlock the screen, and that will cause data loss if there's no backup.
Also note that after replacing the display, software failures may occur:
- Autobrightness is not working.
- The sensor doesn't respond well to touch.
Artifacts appear (stripes, flickering).
It's not always the wizard's fault, sometimes the problem is that the firmware is not compatible with the new display, and then resetting or flashing it will help.
Frequent problems after changing the screen to Mi A3 and how to avoid them
Even after a high-quality repair, the owners of Xiaomi Mi A3 They're in trouble. Let's look at the typical cases and the ways they're addressed.
1.Poor sensor sensitivity
🔹 Reason: Poor quality analog display or poor calibration.
🔹 Decision:
Recalibrate the sensor via the engineering menu (#6484##)
Update the firmware to the latest version.
If it doesn’t help, replace the display with a better one.
2. Yellow or blue screen hue
🔹 Reason: Cheap analogue with poor color reproduction.
🔹 Decision:
— Set up white balance in Settings → Display. → Color mode.
If it doesn’t work, return the phone to the workshop under warranty.
3. The battery goes down fast.
🔹 Reason: New display consumes more power (especially analogues).
🔹 Decision:
- Power saving mode.
Reduce screen waiting time.
Calibrate the battery (discharge to 0% and charge to 100% without interruption).
4. Autobrightness is not working.
🔹 Reason: Damaged light sensor during disassembly.
🔹 Decision:
— Check the settings in Settings → Display. → Autobrightness.
- Reset the settings to factory.
If it does not help, contact the workshop to check the sensor plume.
💡 Useful life hack: If you have broken pixels after replacing the screen, try to “overclock” them with special videos on YouTube (search for “dead pixel fix”). This does not always work, but in 30% of cases it helps.
💡
If after replacing the display, the phone stopped turning on or artifacts (shimmering, stripes) appeared, most likely, the master damaged the plume or poorly glued the screen. Do not try to solve the problem yourself - contact the same workshop (if there is a warranty) or another specialist.
Should I change the display on Xiaomi Mi? A3 independently?
Replacement of the screen with Mi A3 It's a medium-sized repair, and there are a lot of guides and video instructions on the Internet, and there's a high risk of damage to plumes, batteries, motherboards, and what you're going to need, and what pitfalls are waiting for you.
Tools required:
- 🔧 Set of screwdrivers (cross, flat, Pentalobe) P2).
- 🧲 Screen suction cup.
- 🔥 Hair dryer or thermo-air station (for softening glue).
- 📏 Plastic mediators (for display separation).
- 🧴 Clay. B-7000 or double-sided tape (to fix a new screen).
Step-by-step process:
- Turn off the phone and remove the back cover (on the Mi) A3 It's glued, so we heat it with a hair dryer).
- Unscrew all the screws holding the metal plate over the battery.
- Carefully disconnect the battery plume to avoid short circuit.
- Heat the screen around the perimeter and with the help of a suction cup and mediators separate it from the body.
- Disconnect the display and sensor plumes, then install the new module.
- Check the performance before final assembly.
⚠️ Attention: On Mi A3 The cables of the display and sensor are very fragile. If you have never taken your phones apart, it is better not to take risks - the cost of repair after a failed self-replacement can increase by 2-3 times.
📌 Where to buy spare parts?
— Original displays: AliExpress (sellers rated 98%+), Mercado, Official Xiaomi Dealers.
Analogues: Beru.ru, M.Video, local radio market stores.
Average price of a display without work: the original – 6000-9000 ₽, analogue+ — 2 500–4 000 ₽.
Alternatives to Replace Display: When Repair Is Inexpedient
Sometimes changing the screen to Xiaomi Mi A3 It's too expensive compared to the cost of a phone. In 2026, Mi is going to be expensive. A3 In the secondary market it costs 8000-12,000 ₽ (If the repair costs 70-80% of the price of the phone, it makes sense to consider alternatives:
- 📱 Sell it for parts, even with a broken Mi screen. A3 You can sell for 2,000 to 4,000. ₽ (motherboard, camera, battery are in demand).
- 🔄 Some stores (for example, the Messenger or MTS) accept phones with a broken screen in the account of buying a new one.
- 🛠️ If you have another Xiaomi with a faulty motherboard, you can rearrange the display.
- 🎮 Repurpose. Connect the phone to the monitor through USB-C → HDMI and use as a media player or game console (e.g. for emulators).
💰 Financial calculation:
If it costs $8,000 to replace the screen ₽, a telephone in working condition - 10 000 ₽, The repairs are justified, but if the Mi A3 It is already slowing down, discharges quickly or has other problems, it is better to invest in a new smartphone (for example, Redmi Note 12 or other devices). POCO X5).
💡
Before you agree to expensive repairs, evaluate the overall condition of the phone. If there are problems with the battery, speaker or camera in addition to the screen, replacing the display may not be profitable.