Why Xiaomi Reboots on Its Own: A Complete Discussion of Causes and Solutions

You have your own Xiaomi Redmi Note 12 or POCO X5 Pro, when the screen goes out, the logo appears MI, And the device starts to boot from scratch, and it repeats itself over and over again, whether it's playing games or just surfing the Internet, and spontaneous reboots are not only annoying, they also signal serious problems that could lead to a complete failure of the device. In this article, we will analyze all possible causes – from banal overheating to hidden defects of the motherboard – and give specific recommendations on how to return the smartphone stability.

It’s important to understand that if reboots occur regularly (e.g. every 10 to 30 minutes), it’s almost always due to hardware malfunctions. If a smartphone goes into reboot occasionally (once every few days), it’s more likely the software that’s to blame. We’ll help you identify the root of the problem without going to the service center — with tests, logs, and diagnostic tools that are available to every user.

1. CPU overheating: the most common cause

More than 60 percent of spontaneous reboots on Xiaomi smartphones are due to overheating of the chipset.Snapdragon processors (especially the series). 8xx) And Mediatek Dimensity is prone to trottling, which is a forced frequency reduction at critical temperatures, and if the system can't handle cooling, it initiates an emergency reboot to prevent damage to components.

How to check:

• 🔥 Install the app AIDA64 or CPU Monitor and monitor the temperature of the processor in real time. Critical values for the Snapdragon 8 Gen 2 - from 85°C, for Dimensity 9000 - from 90°C.
• 🎮 Run a resource-intensive app (like Genshin Impact or Call of Duty Mobile) and watch the behavior of your smartphone. If you reboot after 10 to 20 minutes of play, it’s overheating.
• 📱 Check the back cover of the smartphone for the presence of battery bloating (this worsens the heat sink).

Decisions:

• 🛠️ Replace the heat paste on the processor (relevant for models older than 2 years). Xiaomi workshops provide this service for 1,500-2,500 ₽.
• 📉 Limit performance in settings: go to Settings → Battery and productivity → Performance mode and select "Balanced" instead of "Maximum".
• 🧊 Use a cooling case or fan stand (such as Black Shark FunCooler Pro).

⚠️ Note: If the processor temperature rises above 100°C in simple tasks (e.g., watching YouTube), this indicates a malfunction of the cooling system or a defect in the motherboard.

2. Firmware failures MIUI: software bugs and conflicts

Operating system MIUI (13-14, especially, is known for its "infantile diseases:

• 🐛 kernel conflicts (for example, after updating with the MIUI 12 on MIUI 14 without fully cleaning the cache).
• 📱 Incompatibility with custom themes or widgets from the Mi Theme Store.
• 🔄 Errors in Google services (especially on devices for the Chinese market) MIUI China ROM).

How to diagnose:

1. Check the error logs through ADB: adb logcat | grep -i "reboot\|crash\|Thermal: If there are lines in the logs thermal_engine or watchdog, the problem is related to overheating or kernel failure.
2. Launch your smartphone in Safe Mode (hold the power button) → long-press on "Switch off" → "Safe Mode Reboot. If the reboots have stopped, third-party software is to blame.

Decisions:

• 🔄 Reset the settings to factory through Settings → The phone. → Resetting. Important: Pre-save data, as this process will delete all user files.
• 📱 Install stable global firmware through the Mi Flash Tool (instruction below). avoid weekly betas MIUI — They often contain critical bugs.
• 🚫 Turn off automatic app updates in Google Play and Mi App Store – sometimes they install incompatible versions of the software.

3. Faulty battery: a hidden threat

The lithium polymer batteries in Xiaomi smartphones are designed for 500-800 charging cycles, after which their capacity drops by 20-30%, and internal resistance increases, which leads to:

• ⚡ Abrupt voltage drawdowns (the smartphone turns off at 30-40% charge).
• 🔋 Spontaneous reboots when connecting charging or a sharp load.
• 💥 Battery bloating (visually visible on the raised back cover or screen glass).

How to check the status of the battery:

1. Enter the number number ##4636## → Select "Battery Information." If your Health status is "Bad" or the capacity is below 80% of the value, you need to change the battery.
2. Use the AccuBattery app to monitor wear, and a drop in capacity below 2,000 mAh is critical for models with 4,000-5,00 mAh batteries.

Decisions:

• 🔧 Replace the battery at the service center.Cost for the Redmi Note 11 — ~1 200 ₽, Xiaomi 13 Pro — ~3 500 ₽.
• 🚫 Do not use fast charging (especially if you are not fast). 120W HyperCharge: If the battery is worn out, it will accelerate its degradation.
• 🔌 Avoid full discharge (keep the charge in the range of 20–80%).

⚠️ Warning: If the battery is swelling, you can't try to discharge or puncture it! This can lead to fire or explosion.

4. Application conflicts: who is to blame?

Some apps (especially those optimized for Samsung or Google Pixel) can cause critical kernel errors on Xiaomi.

• 🎵 Music players with aggressive sound optimization (e.g. Poweramp or other types of music) ViPER4Android).
• 🎮 Game launchers (Xbox Game Pass, NVIDIA GeForce NOW).
• 🔒 VPN-NordVPN, ProtonVPN – they are in conflict with the security system MIUI.
• 📸 Camera Apps (GCam, Open Camera) if not adapted to your model.

How to identify the problem application:

1. After restarting, check the settings immediately. → Annexes → The latest app that was opened before the reboot is most likely to blame.
2. Use it. ADB For analysis of memory dumps: adb shell dumpsys meminfo Look for processes with high consumption PSS (more than 500 MB).

Decisions:

• 🗑️ Remove suspicious apps and check for stability.
• 🔄 Update your apps to the latest versions or roll back to previous ones (via APKMirror).
• 🛠️ Turn off optimization for a specific application: Settings → Annexes → Select the application → Battery → No restrictions.

Remove newly installed programs|Check logs after each reboot|Testing in Safe Mode|Update MIUI last-minute-->

5. Defects of the motherboard: when without repairs can not do

If all previous methods failed, the problem may lie in hardware defects of the motherboard.

• 🔌 Detachment of memory chips (eMMC or UFS) — This causes failures in reading/writing data.
• 📡 Module problems Wi-Fi/Bluetooth (chip WCN or Broadcom).
• ⚡ Failure of the supply chain (especially after falls or bumps).
• 🔥 Burnout of contacts due to prolonged overheating.

Signs of hardware problems:

• The smartphone is rebooted when connected to charging or disconnecting the cable.
• Artifacts appear on the screen (stripes, flickering) before the reboot.
• The device does not turn on after restarting (it is necessary to press the power button for 10-20 seconds).
• Adb logcats have errors of the type E/ERROR ( 1234): [libEGL] load_driver: failed E/mmc: timeout waiting for interrupt.

Decisions:

• 🔧 Chip soldering in the service center (cost from 3000 to 10 000) ₽ model-wise).
• 🔄 Replacement of the motherboard (relevant for flagship Xiaomi 13 Ultra or Black Shark 5 Pro).
• 📱 If the smartphone is warranty – contact the official service center Xiaomi (repair will be free of charge).

⚠️ Warning: If after falling or getting moisture, the smartphone starts to reboot, don't turn it on again! This can short-circuit and final failure.

💡

Before visiting the service, back up your data via adb backup or Mi Cloud. After the board is repaired, all data may be lost.

6.Problems with charger and cable

Non-original chargers or damaged cables can cause power surges to which the system responds by emergency reboot, especially for smartphones with support for fast charging (Quick Charge 4).+, HyperCharge).

Signs of problems with charging:

• The smartphone is rebooted only when connected to the network.
• Charging is interrupted with the message "Charger is not supported".
• The cable or adapter is heated during use.

How to check:

1. Try charging your smartphone with another cable and adapter (preferably original from Xiaomi).
2. Check the voltage at the charger's output with a multimeter. Quick Charge 3.0 should have it in range. 5V–12V.
3. Check the connector. USB-C oxidation or contamination.

Decisions:

• 🔌 Use only certified cables and adapters (e.g. Xiaomi Original) 33W or Baseus 65W).
• 🧹 Clear the connector. USB-C alcohol and soft brush (do not use metal objects!).
• 🔄 Turn off fast charging in settings: Settings → Battery → Charging settings → Turn off fast charging.

💡

Use of non-original chargers with higher power 30W It can damage the power controller on the motherboard.

7 Viruses and Malware: A Hidden Threat

Malware masquerading as legitimate applications (such as flashlights, battery optimizers, or launchers) can cause critical system failures.

• 🕵️‍♂️ Hide your activity (for example, mining cryptocurrency).
• 📱 Bypass the defense MIUI and get root access.
• 💰 Substitute payment system details (e.g. SberPay or Google Pay).

How to detect the virus:

1. Check your smartphone with Dr.Web Light or Malwarebytes (they are better detects malware than built-in Mi Security).
2. Open the Settings. → Apps and sort by installation date: Unknown applications with names like System Update or Android Service are potential threats.
3. Check traffic in Settings → SIM-maps and mobile networks → Traffic: Unexpected data consumption (over 1 GB per day) could point to a botnet.

Decisions:

• 🗑️ Remove suspicious apps and clear the cache through Settings → Warehouse → Clear the cache.
• 🔄 Reset your smartphone to factory settings (see the section about firmware).
• 🔒 Install an ad blocker (such as Blokada) to protect against phishing sites.

8.Update MIUI: When the medicine is worse than the disease

Xiaomi regularly releases updates to the MIUI, But not all of them get tested, like when they're released. MIUI 14.0.4 for Redmi Note 11 users complained about the:

• 🔄 Spontaneous reboots when connecting to Wi-Fi.
• 📵 Losing the network after the reboot.
• 🔋 Fast battery discharge (up to 20% per hour in standby mode).

How to Reverse the Previous MIUI Version:

1. Download stable firmware from miui.com (select the Global Stable version).
2. Go to Settings. → The phone. → Updating the system → tap the icon "⋮" → Select a firmware file.
3. Confirm the installation and wait for the completion (the smartphone will restart 2-3 times).

If no rollback is possible:

• 📱 Use the Mi Flash Tool for forced flashing (see spoiler in section 2).
• 📧 Write in support of Xiaomi through Settings → The phone. → Review – Sometimes they release hot fixes for critical bugs.

💡

Before the update MIUI Always check the reviews on the forums (for example, 4PDA or XDA If more than 10% of users complain of bugs, wait for the next patch.

FAQ: Frequent questions about Xiaomi reboots