Xiaomi Phone Turns On and Off: 12 Reasons and What to Do

If your Xiaomi smartphone starts to turn on and off arbitrarily for no apparent reason, it's not just an annoying little thing, it's a signal of serious problems. This behavior can indicate software problems, hardware failures, or even damage to key components. 80 percent of the time, users ignore the first symptoms until the phone stops turning on at all. We've taken out all the possible causes, from trivial battery discharge to critical firmware errors, and put together step-by-step solutions to help bring the device back to life.

It’s important to understand that a cyclical reboot (or “bootloop”) on Xiaomi is not a homogeneous problem. The Redmi Note 10 Pro may have it due to overheating of the processor, and the Redmi Note 10 Pro has it due to overheating of the processor. POCO X3 — We will not offer universal “all-around advice” but will analyze specific scenarios based on the model and history of use. If you have already tried resetting or replacing the battery without result – in the article you will find alternative methods that are not written in the standard instructions.

Battery discharged or damaged: first suspect

Let's start with the obvious: 9 from 10 In cases of spontaneous shutdowns, it's connected to the battery, even if the indicator shows 30-40% The actual voltage can be critically low, especially for older smartphones. 2 Lithium polymer batteries are lost to the 30% post-container 500 charge-cycle.

How to check:

• 🔋 Connect the original manufacturer’s charger (don’t buy cheap ones!) If the phone only turns on and works stably on charging, the battery is a problem.
• 📊 Install the AccuBattery app (available on Google Play) and check the battery health setting below 80% - a reason to replace it.
• 🔥 Light a flashlight on the battery (if available): bloating or corrosion marks on the contacts - 100% malfunction confirmation.

Important: on Xiaomi models with fast charging (for example, Mi 11 Ultra or Redmi) K50) You'll often see a false charge problem, the phone shows 100%, but it shuts down after 5 minutes, and it's due to damage to the power controller, and it'll only help if you change the charging board at the service center.

⚠️ Warning: If the battery is swelling, don't try to puncture or heat it. Lithium polymer batteries can ignite if damaged. Take the device to service or dispose of it according to the rules.

2.Overheating: when the phone "chokes"

Cyclical reboots when heated – a classic symptom for Xiaomi with Snapdragon processors 8xx (For example, Black Shark 4 or Mi. 10T Pro). Causes:

• 🔥 Clogging of the cooling system (dust in the radiator or dried thermopaste).
• 🎮 Intensive load: games (Genshin Impact, PUBG Mobile, video rendering or cryptocurrency mining.
• ☀️ Operation at temperatures above 35°C (for example, left in the sun in a car).

How to diagnose:

1. Install the app AIDA64 And check the temperature of the processor in the Sensors section.°C in plain, up to 70.°C under load. If the values are higher, the protection goes off and the phone restarts.
2. Try to launch it. 3DMark If the test is interrupted by a reboot, the cooling problem is.

Decisions:

• 🧹 Clean the charging connector and speakers from dust (use a wooden toothpick, non-metal items!).
• 🛠️ Replace the thermopaste (you need to disassemble the phone - if you have no experience, contact the service).
• ❄️ Temporarily limit performance: Enable Energy Saving mode in battery settings.

3. firmware failures: when software "goes crazy"

More than 40% of Xiaomi cyclical reboots are caused by system files being damaged after a failed update or rooting (MIUI EU, Pixel Experiences or those where users tried to root through Magisk.

Typical scenarios:

• 📱 The phone is stuck in the logo MI and reboots every 30 seconds.
• 🔄 After updating,TA Lags appeared, and then spontaneous rebuts.
• 🤖 The device emits an error "Android system is not responding" before turning off.

How to fix it:

1. Hard Reset: Turn off your phone (if it doesn’t respond, shut down the power supply) + Volume up for 10 seconds. Hold power. + Volume up until the Recovery menu appears. select Wipe Data → Wipe All Data (control – volume buttons, confirmation – power). ⚠️ Warning: This will delete all data on your phone, including photos and messages. If you have Mi Cloud backup enabled, restore the data after the reset.
2. Fastboot Flashing (if the reset didn’t help): Download the official firmware for your model from Xiaomi Firmware. Install the Mi Flash Tool on your PC and connect your phone in Fastboot mode (click Power). + Volume down. Select a firmware file and press Flash.

4. Maternity board malfunctions: when everything is serious

If the phone keeps rebooting even after the battery is replaced and flashed, the problem is likely to be the hardware.

Diagnosis at home:

• 🔍 Check the phone for traces of oxidation (green plaque) on the motherboard. To do this, remove the back cover (on models with a non-removable battery, this is difficult - it is better to trust the specialists).
• 💧 If your phone has fallen into water or been operated in a humid environment, use a humidity tester (they are sold in electronics stores) above 15% - a sign of corrosion.
• 🔧 Check the soldering quality of key elements (if you have experience). Often the contacts at the power connector or antenna module leave the contacts.

Decisions:

• 🛠️ Component soldering (power controller, south bridge) – requires professional equipment (sweeter station, microscope).
• 💰 Replacement of the motherboard is the most expensive option (from 5 000 to 15 000 rubles depending on the model).
• 📱 If the phone is warranty, contact Mi Service, and in 60% of cases the fee will be replaced free of charge (even if the warranty does not cover mechanical damage).

5. Application conflicts and viruses

Less commonly, but accurately, some applications can cause critical kernel errors that cause reboots, especially for:

• 🎮 Mods for games (for example, cheats for Free Fire or Call of Duty Mobile).
• 🔓 Applications for bypassing locks (VPN, Tor, Psiphon).
• 📱 Automatic Clicker (Auto Clicker, MacroDroid).
• 🦠 Viruses masquerading as system utilities (e.g. com.android.system.update).

How to find the culprit:

1. Load your phone in Safe Mode (hold the off button). → long tap on "Switch off" → "Safe Mode. If the reboots have stopped, the problem is with third-party software.
2. Check the list of recently installed apps in Settings → Apps → Application Management.
3. Install Malwarebytes or Dr.Web Light and scan the system for viruses.

If you find a suspicious app:

• Remove it through Settings → Apps.
• Clear the cache and data in Settings → Memory → Cleanup.
• Disable Administrator Rights for Unknown Programs in Settings → Passwords and security → Administrator rights.

💡

Before removing the suspicious application, check its permissions in Settings → Annexes → Permits: If a game or flashlight is requested to access SMS, geolocation or administrative rights are a sure sign of malware.

Damage to the power button or plume

Mechanical faults are often overlooked, though they are one of the main causes of spontaneous shutdowns.The power button on Xiaomi wears out over time (especially on Redmi 9 and other models). POCO M3, where it's made of plastic:

• 🔘 The phone turns off when you press a button (even light).
• 🔄 Reboots occur when the device changes position (for example, when you put it in your pocket).
• 🔊 The button "fails" or makes creaks when pressed.

How to check:

1. Carefully move the power button with your finger, and if the phone responds to a light touch, the problem is the micro-switch.
2. Try to turn on the device without using a button: connect the charger – if the phone has booted, but the button does not work, it needs to be replaced.
3. Check the button plume (requires disassembly) and it often leaves the board after a fall.

Decisions:

• 🛠️ Replacing the power button costs 500 to 1,500 rubles. On Xiaomi models with a metal body (for example, Mi 11), this is more difficult due to the adhesive mounting.
• 🔧 If the problem is in the plume - it can be soldered on its own (a soldering iron and experience with small details are needed).
• 📱 Temporary solution: Use the Button Remapper app (root required) to reassign the on to another button (e.g., increase volume).

7.Problems with SIM-card-slot

Few people know, but it's broken. SIM-The card or oxidized contacts in the slot can cause reboots, which is because the communication module is constantly trying to initialize the card, which leads to modem malfunctions.

Signs:

• 📶 The phone turns off when you call or send it. SMS.
• 🔄 Reboots occur after retrieval/insertion SIM-map.
• 📵 A message appears on the screen "SIM-Card not supported" or "Network error".

How to eliminate:

1. Extract. SIM-card and clean the contacts in the slot with alcohol (use a cotton swab).
2. Try inserting another one. SIM-If the problem is gone, replace the old one.
3. Update your network settings: go to Settings → SIM-maps and mobile networks → Access point (APN) and select Reset to default values.
4. If the slot is damaged, it can be replaced (repair cost: 800-2 000 ruble).

💡

On Xiaomi models with support 5G (Like Mi. 11 Lite 5G or Redmi Note 11 Pro+ 5G) Reboots may be due to unstable modem operation. 5G in network settings (Settings) → SIM-map → Preferred type of network → 4G/3G/2G).

8.When to contact the service: 5 signs of critical breakdown

If you've tried all the methods, but the phone still turns on and off, it's time to call the professionals. Here are five signs that self-repair won't help:

• 🔥 Phone heats up to 50°C+ In simple (check through the AIDA64).
• 💥 Reboots are accompanied by cotton or sparking in the battery area.
• 📵 The screen doesn’t turn on, but the phone vibrates and makes boot sounds.
• 🔋 The battery is discharged to 100% post 1-2 hour-long.
• 🛠️ On the motherboard, blackened or bloated elements (capacitors, resistors) are visible).

Where to repair:

Advice: before visiting the service:

• Make a backup of data (if the phone is turned on at least occasionally).
• Check if the service has diagnostic equipment (for example, DC Power Supply to check the board).
• Ask for photos of damage before and after repairs.

FAQ: Frequent questions about Xiaomi reboots