How to take it out properly SIM-Map from Xiaomi phone: instructions for all models

Extraction SIM-Xiaomi smartphone cards seem like a simple procedure, but in practice, users face typical problems, from a jammed tray to the loss of a paper clip to extract. SIM-From the standard procedure to the emergency methods if the tray is stuck or broken, POCO, Mi and Black Shark, as the design of the trays is different.

You will learn how to do without a special tool, what to do if you SIM-The card is stuck inside the phone, and how to avoid damaging contacts, and we'll also analyze common errors that cause users to break trays or lose cards, and give recommendations on how to choose a replacement when a break occurs. At the end of the article, we will answer some of the most common questions, including the compatibility of nano-SIM with different Xiaomi models.

Preparation for extraction SIM-maps: what you need to know

Before you take it out SIM-Make sure the phone is turned off, this will prevent accidental damage to the contacts or failure of the communication module. SIM (For example, some Redmi Notes, but even in this case it is better to be safe.

You'll need:

• 🔧 Paperclip or needle (company with the phone; if lost, an unbended stationery clip will fit).
• 📱 A flat surface (table, window sill) so as not to drop the tray or SIM-map.
• 🔦 Good lighting – the hole to extract the tray is often poorly visible.
• 🧲 Magnet (optional if) SIM-map fell out inside the hull).

Pay attention to the type SIM-Most modern Xiaomi (starting in 2018) use nano-SIM, but in older devices (for example, Redmi). 4X or Mi A1) You may need a micro-SIM. Check this in the specifications of the model or on the official website.

Where is the tray for SIM-card in Xiaomi

The tray is positioned according to the model of the phone, and 90% of the time it is on the right or left side, but there are exceptions:

If you can't find a hole to extract, look in bright light - it can be disguised as a decorative insert (for example, in the Xiaomi Mi Mix series). In IP53-protected models (for example, the Redmi Note 10 Pro), the hole is covered with a rubber plug - it must be carefully moved.

⚠️ Note: Do not confuse the hole for extraction SIM-The microphone usually has a metal mesh, and the IR port has a translucent glass. The tray hole is a small indentation (≈1 mm) without additional components.

Step-by-step instructions: how to remove SIM-standard-map

Follow this algorithm to extract the tray without risking damaging the phone:

1. Turn off the phone (press the power button and select Turn off).
2. Take a paper clip or needle and insert it into the hole on the tray at an angle of 45-60 degrees.
3. Press with moderate force (you don't have to push hard, just a click is enough) The tray should move 1-2 mm.
4. Carefully pull the tray with your fingers until fully removed.
5. Delete. SIM-card, if necessary, replace it or clean the contacts with a dry napkin.
6. Put the tray back before you click (make sure it's up straight!).

Turn off the phone.

Find a hole to extract the tray

Prepare a paper clip or needle

Put your phone on a flat surface

Check if there is any dust in the hole.-->

If the tray is not pushed out the first time, try:

• 🔄 Turn the paperclip in the hole 90 degrees and press again.
• 🧹 Blow the dust hole (sometimes it blocks the mechanism).
• 💡 To direct the flashlight light into the hole - it is possible that the tray has already moved, but not visible.

In Xiaomi’s dual-slot (SIM + microSD) models, the tray may not be fully extended — that’s OK. Don’t pull it by force, or you’ll break the guides.

What to do if there is no paper clip: alternative methods

If you don't have a paper clip or a special needle at hand, you can use improvised tools. The main rule is not to damage the hole (its diameter is ≈ 0.8 mm).

• 📎 Toothpick – sharpen the tip with a knife so that it enters the hole.
• 🧷 Sewing needle (without thread!) is the thinnest and safest option.
• 🖊️ The rod from the gel handle - if you melt the tip with a lighter, it will become stronger.
• 📌 A pin is suitable if its diameter does not exceed 1 mm.

What can't be done:

• ❌ Using a knife or scissors – too thick a blade will damage the mechanism.
• ❌ Insert the paperclip curve - you can bend the guide tray.
• ❌ Apply glue or scotch - the remnants of glue will clog the hole.

If the tray is not extended anyway, try the heating method (suitable for phones that have been in the cold for a long time):

1. Put your phone in a warm place (such as next to the battery) for 5-10 minutes.
2. Try to remove the tray again - sometimes metal parts are compressed by the cold.

Problems in extraction: the tray is stuck or broken

If the tray is not put forward despite all the efforts, the reasons may be as follows:

If the tray is broken and not fixed, you can temporarily secure it with double-sided tape (but this is a short-lived solution).

1. Buy a new tray (cost ≈ 100-300 rubles. on AliExpress or in the service center).
2. Carefully tuck the old tray with a plastic card (not a metal object!).
3. Insert the new tray before the click.

⚠️ Warning: If you hear a crunch when you remove the tray or see that the metal parts have bent, do not insert it back! This can damage the motherboard.

💡

If the tray is stuck and does not respond to pressing a paper clip, try knocking on the phone slightly (in the tray area) with the back of the pencil. Vibration sometimes helps to move the mechanism.

How to get out SIM-card if it is stuck inside the phone

If SIM-The card fell out of the tray and stayed inside the case, don't panic. In most Xiaomi models, it can be removed without disassembly:

1. Turn off the phone and turn it down with the screen.
2. Carefully shake the device - sometimes the card falls out by itself under the influence of gravity.
3. If the card doesn't fall out, use a magnet (for example, from a speaker or refrigerator) and run it along the case in the tray area - metallic. SIM-map will be drawn to the magnet.
4. In extreme cases, use the vacuum cleaner at minimum power (hold the tube at a distance of 1-2 cm from the tray hole).

If the card is stuck deep inside (for example, under the battery), do not try to get it yourself, this is a risk of damaging the plumes.

• 🛠️ Contact the service center (cost of extraction) ≈500–1000 rubles.).
• 📱 If the phone is warranty, do not open it - it will void the warranty.

To prevent re-falling SIM-map:

• 🔄 Check if the card is inserted correctly (chip down, beveled corner to tray).
• 🧴 Apply a thin layer of silicone lubricant to the contacts of the tray (sold in electronics stores).

Frequent Mistakes and How to Avoid Them

Even experienced users sometimes make mistakes when retrieving SIM-These are the most common maps:

• 🔋 Removing the card with the phone on → may cause a failure IMEI loss of network.
• 🔨 Use of too thick objects (screws, nails) → damages the tray mechanism.
• 🧲 Application of strong magnets → It can demagnetize the phone's compass.
• 💦 Moisture entering the tray hole → contact-corrosion.

To avoid problems:

• 📏 Always check the size. SIM-Pre-installing cards (nano-SIM for most Xiaomi after 2018).
• 🧹 Regularly clean the hole of the tray from dust (you can use a toothpick soaked in alcohol).
• 🔄 If your phone often loses network, try reinstalling it. SIM-The map helps sometimes.

💡

Never put it in. SIM-card bent or with incisions - this can damage the tray contacts and lead to loss of signal.

FAQ: Answers to Frequent Questions