How to Clean Xiaomi Redmi Properly 9A at home: from dust to sticky spots

Xiaomi Redmi 9A — One of the most popular budget smartphones, but even it requires regular maintenance, dust in the speakers, greasy marks on the screen, a clogged charging connector — all this not only spoils the appearance, but can lead to breakdowns. In this article, we will analyze how to clean your phone without the risk of damaging its internal components, which means to use, and which are strictly prohibited.

Many Redmi owners 9A face typical problems: the smartphone begins to charge worse due to dirt in the USB-Type C, speakers wheez, and the screen is covered with wiring after rubbing with inappropriate wipes. We've put together proven cleaning methods for each type of contaminant, including the hidden corners of the case where dust gets most often. 9A Xiaomi differs from flagship models due to build features (for example, lack of official protection by standard). IP53).

Before you start, remember: using alcohol-containing liquids above 70% of the concentration can damage the oleophobic coating of the Redmi screen. 9A, And wet tissues with fragrances, you leave a sticky plaque on the plastic case, and then you have step-by-step instructions with photo examples and warnings about typical errors.

1.Preparation for cleaning: what will be needed

Before you start cleaning, gather the necessary tools and tools. 9A It is critical to use soft materials, as its plastic body is easily scratched and the screen does not have tempered glass (unlike the Redmi Note series models:

• 🧴 Isopropyl alcohol 70% (or special wipes for electronics) - for disinfecting the screen and body.
• 🧼 Distilled water (or boiled) - to dilute alcohol, if you need to reduce the concentration.
• 🧻 Microfiber wipe (without pile) - for cleaning the screen and camera.
• 🪥 Toothbrush with soft bristles - for cleaning speakers and connectors.
• 📌 Wooden toothpick (or plastic shoulder blade) – to remove dirt from ports.
• 🔌 Cylinder with compressed air (optional) - for blowing dust from hard-to-reach places.

⚠️ Please note: Never use Redmi to clean up. 9A:

• 🚫 Household chemicals (such as Mr. Proper or Cillit Bang) – it corrodes plastic and rubber seals.
• 🚫 Wet wipes for hands – they contain fats and flavors that leave the film.
• 🚫 Abrasive materials (sandpaper, hard sponges) - they scratch the body and screen.
• 🚫 Acetone or solvents – they break down the adhesive foundations under the screen and logo.

If you do not have isopropyl alcohol, it can be replaced with vodka without additives (concentration). ~40%), but the disinfection efficiency will be lower, and for speakers and connectors, it is better to use special cleaning gels (for example, for speakers and connectors, WD-40 Specialist Contact Cleaner, but you need to apply them carefully, avoiding getting inside the case.

Screen and camera cleaning: no divorces and scratches

Redmi screen 9A It's covered in a thin oleophobic layer that eventually wears off greasy fingers and improper cleaning:

1. Turn off your phone – this will allow you to see the contamination better and avoid accidental pressing.
2. Blow dust off the screen with a spray of compressed air (keep it at a distance of 10-15 cm).
3. Apply the cleaning solution on a microfibre wipe (not on the screen!). For the solution, mix isopropyl alcohol 70% with distilled water in a 1:1 ratio.
4. Wipe the screen in light circular motions, starting from the center to the edges. Don't push, it can damage the matrix.
5. Remove the moisture residue with the dry part of the napkin.

To clean the camera, use a cotton swab dipped in the same solution. Carefully walk along the glass of the lens without pressing it. If the camera has persistent stains (for example, from cream or makeup), use special wipes for optics (sold in photo stores).

⚠️ Warning: If the screen becomes sticky after cleaning or if you have a swelling, you have used too concentrated alcohol or a soaked napkin, in which case wipe the screen with a dry microfiber and apply a protective film (such as Spigen Glas.tR) to restore the slip.

Turn off the phone.|Remove dust with compressed air|Use only microfibers|Do not pour liquid directly onto the screen|Wipe the camera separately-->

3. Cleaning the speakers and microphone: return clear sound

Redmi speakers and microphone 9A They are most likely to get clogged with dust and villi, which leads to wheezing during calls or music playback, and in this model, the speaker is located on the bottom end (near the charging connector), and the microphone is on the top (near the 3.5 mm audio jack:

For the speaker:

1. Take a toothbrush with soft bristles and gently clean the speaker grille with movements along the slots.
2. If the dust is not removed, use compressed air (short pulses, without bringing the balloon closer to 5 cm).
3. For persistent contaminants, moisten the cotton swab in isopropyl alcohol and walk along the edges of the grille.

For the microphone:

• 🎤 Use a plastic spatula (or toothpick) to gently tamper with contamination from the hole.
• 💨 Blow the microphone with compressed air (do not direct the jet directly into the hole - this can damage the membrane).
• 🚫 Do not use metal objects (needles, pins) – they can bend the microphone grid.

If the sound has not recovered after cleaning, the problem may be a software failure. Try resetting the sound settings: go to Settings → Sound. → Additionally. → Resetting the sound settings.

4. Connector cleanup: USB-Type C and 3.5mm audio

USB Type C connector in Redmi 9A — Dust, pile and debris build up inside, causing the phone to stop charging or to identify the cable as an "unidentified device:

1. Turn off the phone and remove all the cables.
2. Illuminate the connector with a flashlight to assess the degree of contamination.
3. Use a plastic spatula or toothpick to gently pick out the garbage. Movements should be parallel to the contacts, not across!
4. For final cleaning, use compressed air (2-3 short pulses).
5. If the contacts are oxidized (a green coating appears), wipe them with a cotton swab soaked in isopropyl alcohol.

The same toothpick is good for a 3.5mm audio jack, but you need to be even more careful, because there's fragile mechanics inside, and if the headphones don't lock well or the sound disappears when the plug moves, the problem may be the worn connector, not the pollution.

⚠️ Warning: If after cleaning the phone still doesn't charge, check the cable and power supply.Redmi 9A Responsive to left-hand chargers – use only original accessories or Quick Charge 3.0 certified.

5. Removal of dust from the case and buttons

Redmi Corps 9A It's assembled without official dust protection, so over time, dirt gets under the buttons and into the joints to clean them up:

• 🔄 Volume and power buttons: Use a cotton swab dipped in alcohol and walk gently along the edges of the buttons. You can use compressed air (short pulses) to remove dust from under them).
• 📱 Body joints: Walk around the perimeter of the phone with a microfiber wipe soaked in soap solution (1 drop of liquid soap per 100 ml of water.
• 🔊 Microphone hole on the back: Clean with a toothpick wrapped in a thin cloth (such as a handkerchief).

If the buttons start to stick or press badly, the cause may be moisture (even if the phone is not bathed), in this case, the washing with alcohol will help:

1. Wet the cotton swab in isopropyl alcohol.
2. Gently wet the area around the button (don’t pour alcohol directly on the phone!).
3. Wait 10-15 minutes for the alcohol to evaporate, then check the button.

⚠️ Warning: If after cleaning the buttons still don't work, don't try to disassemble the phone yourself.Redmi 9A plumes of buttons soldered to the motherboard, and with a careless opening, you can damage them.

💡

To reduce the dust accumulated in the connectors, store the phone in a case with stubs (for example, Xiaomi Redmi). 9A It protects not only from scratches, but also from garbage entering ports.

Removal of persistent contaminants: glue, paint, sticker marks

Sometimes on the Redmi hull. 9A And you have complex contaminants, sticker marks, film glue, paint or ink, and they can be removed:

• 🧴 Alcohol wipes: Effective against glue and scotch marks. Wipe the contaminated area and wait 1-2 minutes, then repeat.
• 🧼 Soap solution: Suitable for removing paint or ink. Moisten the napkin in warm soapy water, wipe the stain and immediately wipe dry.
• 🧊 Ice: If the phone got gum, apply ice to it for 1-2 minutes to harden, then gently scrape off with a plastic spatula.

To remove scratches on the plastic case, you can use:

• 🔥 Polyrole for plastic (for example, Displex) – applied to a napkin and rubbed in circular movements.
• 💡 Toothpaste (without abrasive particles) - apply to a scratch, rub with a soft cloth, then rinse.

⚠️ Note: Do not use acetone or solvent 646 to remove glue, as these corrode plastic and can erase the label from the back cover (e.g. serial number or certification data).

💡

To remove persistent spots, always test the product first on a low-conspicuous area of the case (for example, on the end of the phone).

7. Phone Disinfection: How to Kill Bacteria and Viruses

A smartphone is one of the dirtiest things in everyday life, and it's a place where bacteria, viruses and fungi accumulate on its surface, especially if you use your phone frequently in public. 9A:

1. Turn off the phone and remove the case (it also needs to be processed separately).
2. Wipe the body and screen with a wipe soaked in 70% isopropyl alcohol or special antiseptics for electronics (such as Apple Clorox Wipes).
3. Treat the connectors and buttons with a cotton swab dipped in the same solution.
4. Let the phone dry for 5-10 minutes before turning on.

For the cover, use:

• 🧼 Soap solution - if the case is silicone or plastic.
• 🧺 Hand-washing (for fabric covers) with soft detergent.
• 🚫 Do not use bleach – it destroys the material.

If you use your phone often outside, consider buying an antibacterial film (like Spigen NeoFlex with silver ions), which reduces the number of bacteria on the screen by 99%.

8.Prevention: How to Clean Redmi Less 9A

To keep your phone clean for longer:

• 📱 Use a cover and glass - they protect against scratches and dust. - For Redmi 9A tempered glass will do. 9H (Xiaomi Mi Protective Film, for example).
• 🧴 Wipe the screen 1-2 times a day with a dry microfiber wipe (for example, the one that comes with glasses).
• 🔌 Keep your phone in a dry place – humidity accelerates the accumulation of dust in the connectors.
• 🚫 Do not eat or smoke near your phone – fat and nicotine settle on the body and screen.
• 🔄 Once a month, blow the connectors with compressed air, even if there is no visible contamination.

If you drop your phone frequently or work in dusty environments (such as construction), consider buying a sealed case (such as Lifeproof). FRĒ). It protects not only from dirt, but also from moisture.

It is also useful to turn off the phone during cleaning – this reduces the risk of short circuits if moisture accidentally gets inside the case.

💡

Regular cleaning prolongs the life of the phone: dust in the connectors can cause corrosion of contacts, and dirt under the buttons - their sticking.

FAQ: Frequent questions about cleaning Xiaomi Redmi 9A