Extraction SIM-Xiaomi smartphone cards seem like a simple task, but in practice users face a lot of nuances: from a jammed tray to the risk of damaging contacts, POCO Mi is different from the classic Samsung or iPhone solutions, and in this article we will discuss all the ways of extraction, including emergency methods for “stuck” cards, and explain how to avoid the typical errors that lead to breakdowns.
It is important to understand that the procedure depends not only on the model, but also on the type. SIM-For example, the Xiaomi 13 Pro uses a hybrid slot for two nano-SIM or one nano-SIM. + microSD, and in budget Redmi A2 — single nest SIM. We will describe the differences in detail and give recommendations for each case, and you will also learn what to do if the extraction paper clip is lost, and only the available tools are at hand.
Preparation for extraction SIM-maps: what you need to know
Before you start retrieving, make sure the phone is turned off. This is not just a recommendation - in some Xiaomi models (such as the POCO F5), when the SIM is hot, the protection against static electricity can work, which will cause the communication module to fail.
- 🔋 Battery charge: if the battery is less than 10% discharged, it is better to recharge the device.
- 📱 Phone model: specify what type of tray is used (single, dual, hybrid). This information is available in the manual or on the official website of Xiaomi in the specifications section.
- 🔧 Tool: Prepare a special key (company) or a paper clip. Using pins or needles can damage the locking mechanism of the tray in spring-locked models (for example, the Redmi Note 12).
If you've never taken out SIM-In some regional versions (for example, for India), there may be a seal on the slot, the violation of which will void the warranty.
Standard method: extraction with a key or paper clip
This is a basic method that is suitable for 90% of Xiaomi models, including the Redmi 10, POCO X5 and Mi 11.
- Find the extraction hole on the side of the phone, usually on the right side (when you look at the screen), but on some models (for example, Xiaomi 12T) on the left.
- Put the key or the unbended paperclip into the hole to the point. Press with force until the tray is extended 1-2 mm.
- Pull the tray carefully with your fingers, without putting too much effort. If it does not come out, check if it is skewed. SIM-map.
In hybrid slots (for example, in the Redmi Note 11 Pro+), the tray can stick due to the simultaneous use of two SIMs or microSDs.
☑️ What to do if the tray is jammed
If the tray still does not come out, do not try to pull it out with pliers - this will damage the plastic guides.
Alternative methods: if there is no key or tray jammed
Situations where there is no special tool at hand often happen. Here are proven ways that will not damage the phone:
- 📎 Paperclip or stationery button: unwind the paperclip so that you get a straight end of 2-3 cm. Insert it into the hole at an angle of 90° case-wise.
- 🧲 Magnet: If the tray is metal (like in Xiaomi 13 Ultra), bring a powerful neodymium magnet to the location SIM-The tray can move under the influence of a magnetic field.
- 📦 Tape or Scotch: Stick a piece of tape to the sticking edge of the tray and pull. This method works if the tray is extended at least 1 mm.
For models with a retractable mechanism (for example, Xiaomi Mix Fold 2), flat items (knives, credit cards) are strongly discouraged, as this can bend the guides.
⚠️ Warning: If the tray does not extend after 3-4 attempts, stop manipulating, POCO F4 GT) You use a two-stage lock, you push the tray halfway, you press it again, and you force it to break the lock.
What to do if SIM-card stuck in the slot?
Features of extraction in popular Xiaomi models
The design of the trays varies depending on the series and year of release, and the table below shows the key differences for popular models:
| Model | Type of tray | Location of the hole | Features |
|---|---|---|---|
| Redmi Note 12 Pro+ | Hybrid (2 nano-SIM or 1 nano-SIM + microSD) | Right edge, top end | The tray is delayed due to a spring shock absorber |
| POCO X5 Pro | Double (2 nano-SIM) | Left face, closer to the bottom corner | Smaller diameter hole – a thin paper clip is needed |
| Xiaomi 13 Lite | Single (1 nano-SIM) | Right side, next to the power button | A tray without a fixator - can fall out when the phone is tilted |
| Redmi A2+ | Hybrid (2 nano-SIM or 1 nano-SIM + microSD) | Top face, next to 3.5 mm connector | Plastic tray - fragile, do not make efforts |
Flagship models like the Xiaomi 14 sometimes use a double-lock mechanism, which means that after you press the key, the tray is not fully extended, but only 50%, and you need to re-press the key or slightly pull the tray with your fingers to fully extract it.
💡
If you change often SIM-If you're a card card, buy a metal tray on AliExpress, it's stronger than plastic and less likely to break when you're using it heavily.
Frequent Mistakes and How to Avoid Them
Even experienced users sometimes make mistakes that lead to breakdowns.
- 🔄 Removal with the phone on: in models with Dual 5G (Like Redmi. K60) This can cause the modem to reset.
- 🔨 Using the wrong tools: toothpicks or matches crumble and get stuck in the hole. If there is no clip, it is better to use a guitar string (diameter 0.2-0.3 mm).
- 📏 Wrong pruning SIM-Cards: in hybrid slots (e.g, POCO M5) microSD and nano-SIM must be inserted strictly on the markup. If the card is cut curved, the tray will jam.
Another common problem is getting dust into the mechanism, and if the phone is often used in dusty environments (like construction), blow the hole with compressed air before removing the tray (you can use a can to clean the keyboard), which will prevent jamming due to the accumulation of dirt.
⚠️ Attention: in models with IP53 protection (e.g. Redmi) 10C) The tray extraction hole is covered with a rubber plug, and if it is damaged, the phone will lose its moisture protection.
Emergency situations: SIM-card stuck or tray broke
If the tray broke down or SIM-The map fell inside the case, don't panic:
- For a broken tray: Use tweezers to carefully remove the rest. Don't pull the wires or contacts! If the tray has fallen apart, try to remove them one at a time, starting with the largest.
For the stuck SIM-map
- Turn the phone down and shake it a little bit. Sometimes the card comes out.
- If the card is visible in the slot, use a plastic card (such as a bank card) to pick it up.
In the most difficult cases (for example, if the card fell between the case and the battery), you will need to disassemble the phone. In Xiaomi models with a non-removable battery (for example, the Mi 11 Ultra), self-disassembly will cancel the warranty and can damage the plumes. Cost of getting stuck SIM-cards usually do not exceed 500-1000 rubles.
💡
If the tray breaks, don’t use superglue for repairs – it can get to the contacts. SIM-You can order a new tray (the article can be found on the Xiaomi website using the phone model).
How do you put it in? SIM-Map back: nuances for Xiaomi
Reverse installation SIM-The maps have features, too:
- 📏 Check the format: Xiaomi only uses nano-SIM. If you have a micro-SIM, trim it to a template or order a new one in the operator’s cabin.
- 🔄 Map orientation: There is a diagram on the tray showing which side to insert SIM. Contacts should be directed downwards and the bevelled corner should be directed towards the outer edge of the phone.
- 🔒 Tray fixation: Once you have the cards installed, press the tray before you click. In spring-powered models (like the Redmi Note 12), you'll have two clicks, which is normal.
After installation, turn on your phone and check the network.
- Reset the device.
- Check if it is inserted correctly SIM-map (sometimes it shifts when fixing the tray).
- Go to Settings. → SIM-Maps and mobile networks and select priority network manually.
💡
After installation SIM-The phone can't see the network, so try to wipe the contacts of the card and the tray with an alcohol wipe.