How to get a filter from a vertical vacuum cleaner Xiaomi: instructions for all models

Xiaomi vertical vacuum cleaners are among the most popular in Russia due to their combination of power, compactness and convenience. But even the most advanced technology requires regular maintenance, and filter cleaning is a key point to maintain performance. Many users face the problem of how to properly remove the filter without damaging the mounts or seals? This is especially true for models with a cyclone system, where the filters are hidden under several layers of the case.

In this article, we will discuss all the ways to access filters in Xiaomi vertical vacuum cleaners (Mi Handheld Vacuum, MiJia, Dreame, etc.), including hidden latches, typical dismantling errors and care tips. I usually have a hand!, how to tell the difference! HEPA-The filter is from the washing machine, and what to do if the filter is stuck with dust, and also the filter compatibility table for different models and answers to frequent questions.

If your vacuum cleaner is getting worse, making unusual sounds, or overheating, 90 percent of the time, it's a clogged filter, but before you pull it out, make sure it's not the other thing.

• 🔋 Check the battery power - at a low level, the suction power drops.
• 🌀 Inspect the cyclone block – sometimes debris gets stuck in the tube rather than in the filter.
• 🔊 Listen to the sound of work - wheezing or whistling may indicate a blockage in the hose.

1. Types of filters in vertical vacuum cleaners Xiaomi: what do you have?

Before you extract the filter, you need to understand what type of filter you are dealing with. Xiaomi vacuum cleaners use three main types of filters, and each has its own nuances of dismantling:

1. Pre-motor (sponge) filter - protects the engine from large particles, usually washable, located in front of the turbine.
2. HEPA-filter - picks up fine dust and allergens. 6-12 months or months (with the possibility of washing).
3. Cyclone filter -- built into the dust collector, separates debris from air, often combined with a different air. HEPA.

How do you distinguish them visually?

⚠️ Attention: In Dreame models V11 newer HEPA-The filter is often integrated into the cyclone block. HEPA You can use a plastic container, don't try to disassemble it, just rinse the entire block under the water stream.

2. Step-by-step instructions: how to get a filter from a Xiaomi vacuum cleaner

There's no one-size-fits-all, it depends on the model, and we've compiled instructions for the most common series, and if your model isn't on the list, you should follow the general algorithm.

Disconnect the vacuum cleaner from the network (remove the battery)

Clean the dust collector of garbage

Prepare a dry cloth and tweezers (in case of stuck fasteners)

Photograph the initial position of the details-->

Models of Mi Handheld Vacuum (G9, G10, G11)

There are two filters in these vacuum cleaners: pre-motor (sponge) and HEPA (To get them out:

1. Remove the dust collector by pressing the Release button (usually red).
2. Unscrew the lid at the bottom of the handle (turn counterclockwise).
3. Under the lid you will see a sponge filter - gently pull it up behind the plastic handle.
4. To access HEPA-remove the upper cover of the case (latches on the sides) the filter is located under the metal mesh.

2.2. Models of MiJia 1C/1S dreame V9/V10

There's a deeper filter here.

1. Disconnect the vacuum cleaner tube from the main unit.
2. Turn over the vacuum cleaner and find a round cover with grooved edges (usually labeled Filter).
3. Turn the lid on 90.° counterclockwise and take it off. Underneath it is a cyclone filter with a HEPA-component.
4. To separate HEPA from the cyclone block, click on the plastic latches on the sides.

💡 Useful tip: If the lid doesn't lend itself, don't force! in MiJia models 1S Sometimes you need to remove the battery first (Battery Release button at the bottom of the case).

💡

If the filter is "stuck" to the body, wrap it with a plastic bag and put it in the freezer for 15 minutes - the plastic will shrink and easily separate.

2.3. Dreame models V11/V12 space-system 2.0

These vacuum cleaners use a modular filter, which is extracted together with the vacuum collector:

1. Press the Unlock button on the dust collector and remove it.
2. Inside the container you will see a cyclone separator with a built-in HEPA-Pull the plastic handle up.
3. For deep cleaning, disassemble the separator: turn the top part counterclockwise and remove it.

⚠️ Attention: In Dreame V12 In case of incorrect filter assembly, the vacuum cleaner may give an error E3 (Make sure all sealing gums are in place!

3. How to Clean the Filter: Washable vs. Disposable

The mistake of many users is to try to wash disposable HEPA-This causes them to warp and lose their filter properties. How do you know which filter you have?

• 🔄 Washable: It's dense, often with a plastic frame, and it has the inscription Washable on it.
• 🚫 Disposable - thin, paper or nonwoven material Marked: Replace Only or Non-Washable.

Instructions for cleaning the washing filter:

1. Wash it under warm water (no more than 40).°C) without detergents.
2. To remove persistent contaminants, use a soft brush (for example, a toothbrush).
3. Dry thoroughly for 24 hours in a ventilated place (not on the battery!).
4. Before installation, check the integrity of the sealing rubber bands.

💡 Secret: In Dreame models V11 cyclone filter can be cleaned in the dishwasher (mode "delicate cleaning", without rinse). But no more than 1 time in 3 months!

4 Frequent errors in filter removal and how to avoid them

Even experienced users sometimes make mistakes that lead to breakdowns. TOP-5 Failures and How to Prevent Them:

• 🔧 Force instead of technique, they try to pull the filter out without opening the latches.
• 🔄 Incorrect assembly, you put the filter upside down, and then you get the vacuum cleaner to lose power, you get an error. E2 (misflow).
• 💦 Installation of a wet filter - they rush to collect the vacuum cleaner before drying out.
• 🧹 Ignoring the seals -- not checking the rubber bands for wear and tear -- the consequence is that dust gets into the engine, reducing the life of the engine.
• 🔍 Confusion with filter models -- buying non-original parts, consequence: filter doesn't fit the size, vacuum cleaner heats up.

⚠️ Note: In Xiaomi vacuum cleaners with Smart Seal system (for example, Dreame) V12) The filter has a magnetic lock, and if you hear a click when you're installing it, it's not right!

5. Compatibility table of filters for vertical vacuum cleaners Xiaomi

Not all filters are interchangeable! Below are the current articles for popular models (data for 2026):

💡 In 2023, Xiaomi updated the design of filters for Dreame V12 — They are now equipped with silver antibacterial coatings. Old filters (until 2022) are not compatible!

6.Where to buy original filters and how not to run into a fake

The original filters for Xiaomi can be purchased:

• 🛒 Xiaomi official store - a guarantee of quality, but the price is higher 20-30%.

Signs of forgery:

• 🏷️ There is no hologram or barcode on the package.
• 📦 Packaging of thin cardboard (original - dense, with embossed).
• 🔍 The filter is thinner than the original or has uneven edges.
• 💰 Prices below 50% of the market average (for example, HEPA for Dreame V12 It's not worth less than 800.₽).

⚠️ Warning: Fake filters are often made from low-quality materials that melt when heated, which can cause microplastics to enter the air and cause turbine failure.

💡

Buy filters that are labeled Original or Genuine, and the savings on fakes will result in a vacuum cleaner repair cost. 3-5 thousand rubles.

7. Alternative methods of filter cleaning without removal

If the filter is clogged but you can’t reach it (for example, a latch jammed), try emergency methods:

• 🌬️ Pressure air purge – use a can to clean the equipment (keep at a distance of 10 cm!).
• 🧲 Magnetic cleaning – for metal particles in a cyclone filter, bring a powerful neodymium magnet.
• 🧼 Dry brushing - take a brush with a long pile and gently clean the net through the holes in the case.

💡 Important: These methods are not a substitute for full cleaning; they only temporarily restore performance. 30-40% pollution.

FAQ: Frequent questions about filters in Xiaomi vacuum cleaners