Xiaomi Wellskins Instrument of Wrinkles WX MJ809 — This is a new generation of portable devices that combine RF-radiofrequency therapy, LED-Photorejuvenation and microcurrent stimulation to combat wrinkles, skin tone loss and pigmentation, developed with the help of dermatologists, is positioned as an alternative to salon treatments, but with the possibility of use in the home. However, without the right technique, even the most advanced device may not give the expected effect – or, worse, harm the skin.
In this article, we will discuss the step-by-step instructions for working with WX MJ809, We will reveal the nuances of skin preparation, choose the optimal modes for different areas of the face, and also warn against typical mistakes that users make. We're going to focus on combining the device with care cosmetics, because properly selected serums and creams increase the effect of the procedures by 30-40%. RF-devices, but did not achieve the result - this instruction will help to systematically approach the issue.
Technical characteristics of Xiaomi Wellskins WX MJ809: hull
Before you go into practice, it is important to understand what technologies are embedded in the device and how they affect the skin. WX MJ809 — It's not just a massage stick, it's a full-fledged multifunctional machine with a scientific base, and the chart below shows the key parameters that determine its effectiveness:
| Technology | Parameters | Skin effect |
|---|---|---|
| RF-radiofrequency | Frequency 1 MHz, power up to 5 W, penetration depth 3-5 mm | Stimulation of collagen production, contours tightening, wrinkle reduction |
| LED-phototherapy | 3 modes: Red (630 nm), Blue (415 nm), Green (520 nm) | Red - rejuvenation, blue - fight against acne, green - lightening pigmentation |
| Microcurrents | Pulse current 0.1–0.5 mA, frequency 10–100 Hz | Improvement of lymphatic drainage, removal of swelling, muscle toning |
| Ion mesotherapy | Polarity "+" and - for the delivery of active substances | Increased penetration of serums and creams into the deep layers of the skin |
Feature WX MJ809 — It's automatic intensity control, depending on the area of the face, for example, for the area around the eyes, the device reduces the power. RF-This makes it different from budget-friendly ones, where you have to adjust manually, risking burns or insufficient effects.
Another plus is wireless charging and a 1200 mAh battery, which is enough for 10-12 full procedures: RF-electrode for radiofrequency exposure and LED-Photorejuvenation panel: The microcurrent function is built into the main body and activated by a separate button.
Skin and apparatus preparation: why it is more important than the procedure itself
80% of users fail to prepare properly, without proper cleansing and moisturizing of the skin, the effectiveness of the skin is WX MJ809 It's down by a factor of 2-3, and your risk of irritation increases:
- Double cleansing: first hydrophilic oil or micellar water, then foam/gel for washing with pH 5.5. This removes not only makeup, but also sebum, which interferes with the penetration of radio frequencies.
- Exfoliation (1–2 once a week: use enzyme peeling or AHA/BHA-acids (e.g, 5% This will increase the penetration of active substances into the 40%.
- Tonic: Rub your face with an alcohol-free tonic with hyaluronic acid – this will restore pH and prepare the skin for the procedure.
- Applying conductive gel: Use only special gels for RF-Wellskins Conductive Gel, a conventional ultrasonic gel or water will not work!
What can't be done:
- 🚫 Apply oil or creams on the skin based on oil – they create a film that blocks RF-wavelength.
- 🚫 Use the device on irritated skin (after peeling, sunburn, Botox injections in less than 2 weeks).
- 🚫 Skip the moisturization stage - dry skin heats up more, which can lead to microburns.
Cleanse the skin with a two-step method|Conduct a light exfoliation (if necessary)|Apply the conductive gel with a thin layer|Make sure the device is charged at least 30 times%|Select a program according to the purpose-->
Important: If you are using ion mesotherapy, apply serum first (such as with vitamin C or peptides), then turn on the regimen "+" to deliver active substances to the skin, and after the procedure switch to - to "seal" the result.
💡
To enhance the effect RF-before the procedure, apply serum with matrix peptides (for example, Matrixyl 3000) - they stimulate fibroblasts, which under the influence of radio frequencies begin to actively synthesize collagen.
Step-by-step instructions: how to carry out the procedure on different areas of the face
There is no universal recipe, each area of the face requires a different approach, and here is a detailed analysis of the techniques for the forehead, eye area, cheekbones and chin, as well as the parameters of the apparatus for each area.
1. Forehead and eyebrow (fighting horizontal wrinkles)
Use it. RF-the nozzle at the intensity level of 2-3 (out of 5:
- 🔄 Spiral movements from the center of the forehead to the temples (3 circles on each side).
- ↕️ Vertical passages from the eyebrows to the hairline (5-7 times).
Exposure time: 3-4 minutes. RF turn on red LED 2 minutes to fix the effect.
2. the area around the eyes ("crow's feet" and dark circles)
The skin is thinner here, so:
- 🔘 Use the minimum intensity RF (level 1).
- 👆 Bone orbit only (don't touch the eyelid!) Direction: from the inner corner of the eye to the outer corner of the eye.
- ⚡ Turn on microcurrents for 2 minutes for lymphatic drainage (mode "–").
Critical: do not press on the skin - the nozzle should slide without pressure, otherwise you risk stretching the thin skin of the eyelids.
Bones and nasolabial folds (oval lift)
This is the zone where RF It's the maximum effect:
- 📶 Intensity RF: level 3-to-4.
- 🔄 Technique: "eight" - from the wings of the nose to the earlobes (5 times on each side).
- 💡 After RF Use the green. LED (if there is pigmentation or red (for rejuvenation).
4.Chin and neck (second chin fold)
For this zone, combine:
- 🔽 RF + Microcurrents: Intensity 4, movement from the bottom up (against gravity).
- 🕒 Time: 5 minutes on the chin, 3 minutes on the neck.
Total procedure time: 15-20 minutes. The optimal frequency: 2-3 times a week in the first 2 months, then 1 time a week to maintain the result.
What to do if the skin turns red after the procedure?
Compatibility with cosmetics: what to apply before and after the procedure
Efficiency WX MJ809 It depends on what you use with it, 50 percent, and the table below is the compatibility of active ingredients with the technology of the machine:
| Machine technology | Recommended ingredients | What to avoid |
|---|---|---|
| RF-radiofrequency | Peptides, hyaluronic acid, vitamin C, niacinamide | Retinol (can cause irritation), alcohol-containing products |
| LED-phototherapy | Azelaic acid (for blue) LED), arbutin (for green) LED) | Essential oils (can be oxidized by light) |
| Microcurrents | Amino acids, placenta extract, caffeine (for lymphatic drainage) | Mineral oils (block conduction) |
Deposit scheme:
- After purification: serum with peptides or vitamin C (for RF/LED).
- After the procedure: a soothing cream with panthenol or ceramides.
- Overnight: Retinoid (in 2-3 hours after the procedure, if there is no irritation).
Example of combination for mature skin (40)+): Morning: RF + slurry → SPF 50 Evening: Microcurrents + peptide-cream → 30 minutes later, tretinoin 0.025%.
💡
Never use Xiaomi. WX MJ809 along with products containing aluminum salts (antiperspirants) or benzoyl peroxide - this can cause chemical burns under the influence of RF-radiation.
Typical Mistakes and How to Avoid Them: The Experience of Dermatologists
Even with the instructions, many users make mistakes that nullify all efforts. TOP-5 Failures and How to Correct Them:
- Use on dirty skin Remains of makeup or cream create a barrier to RF-Solution: Always double clean (see section on preparation).
- Wrong angle of inclination of the nozzle If you keep the device perpendicular to the skin, RF-So, tilt the nozzle at a 30-45 angle.° face-surface.
- Exceeding the procedure time More than 20 minutes RF-The solution: stick to the timer of the device (it turns off automatically).
- Ignoring neck and neckline areas Wrinkles appear earlier than on the face. Solution: Take 3-5 minutes in each session.
- Lack of care after the skin procedure RF Loses moisture 2 times faster Solution: Apply a cream with hyaluronic acid immediately after the session.
Another common problem is irregularity. Many people drop 2-3 treatments before they get results.Remember: The first visible changes (contours tightening, wrinkles reduction) appear after 6-8 sessions. The full course is 12-15 procedures.
Comparison with salon procedures and analogues
Many people doubt whether to buy. WX MJ809, So, if I could go to a beautician, let's see if it's more profitable to have a home appliance or a professional procedure:
| Criteria | Xiaomi WX MJ809 | Salon RF-therapy | Analogues (NuFace, Foreo) |
|---|---|---|---|
| Course cost (10 procedures) | ~5 000 ₽ (machine-price) | 15 000–30 000 ₽ | 8 000–15 000 ₽ |
| Depth of penetration RF | 3.5 mm | 10 mm | 1-3 mm |
| Additional functions | RF + LED + microcurrent + iontophoresis | Only RF (sometimes + ultrasound) | Microcurrents or LED (But not all of it) |
| Convenience | Use of the home at all times | We need to sign up, go to the clinic. | Requires regular recharging |
When to choose WX MJ809:
- 💰 You want to save money on salon procedures.
- 🏠 You need to be able to have sessions at home.
- 🔄 You are ready for regular procedures (2-3 times a week).
When is the best time to go to a cosmetologist:
- 🩺 You have deep wrinkles or ptosis (you need professional equipment).
- ⏳ You need a quick result (for example, before an important event).
- 🚨 There are contraindications (couperosis, oncology, pregnancy).
Compared to analogues (e.g. NuFace or Foreo) UFO) WX MJ809 It's a big winner because it combines four technologies in one device, but it has a disadvantage, which is a less ergonomic eye nozzle (unlike NuFace, which has a special mini nozzle).
Contraindications and precautions
Despite the safety of the home RF-machine, WX MJ809 It has a number of absolute and relative contraindications, and ignoring them can lead to burns, skin problems, or even systemic reactions.
⚠️ Note: If you have metal implants in your face (such as titanium plates after a fracture), use RF-Radio waves can heat metal, causing local burns.
Absolute contraindications (forbidden to use):
- 🚫 Pregnancy and lactation (influence) RF fruitless).
- 🚫 Oncological diseases (any localization).
- 🚫 epilepsy (LED-flare-ups can trigger an attack).
- 🚫 Severe forms of rosacea or cuperosis (RF redness).
Relative contraindications (you need a doctor's consultation):
- ⚠️ Diabetes (slow healing of the skin).
- ⚠️ Taking retinoids inside (increases skin sensitivity).
- ⚠️ Fresh scars or wounds (less than 6 months).
- ⚠️ Active phase of herpes.
If you have a pacemaker or other electronic implants, consult a cardiologist before using the device. RF-Theoretically, waves can interfere with the operation of the device.
⚠️ Attention: Do not use WX MJ809 on the thyroid gland (front of the neck) - long RF-The effects on this area have not been studied.